Transfer supports shall be provided for use with the transfer sides required by M301.2.3 and shall comply with M305.2.
Search Results "Bed Height"
-
M301.3.1 Transfer Supports
-
M301.3 Supports
Transfer supports, stirrups, and reclining surfaces shall comply with M301.3.
-
M301.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided. Where the incline of the back support can be modified while in use, head and...
-
407.12 Reach Height
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.12.2 or 407.12.3 according to its position established in 407.12.1 for a side reach or...
-
11B-411.3.3.1 Height
The height of the reopening device shall comply with Section 11B-407.3.3.1....
-
11B-1009.5.3 Height
The height of the transfer platform shall comply with Section 11B-1009.4.2....
-
11B-411.3.3.1 Height
The height of the reopening device shall comply with Section 11B-407.3.3.1....
-
11B-1009.5.3 Height
The height of the transfer platform shall comply with Section 11B-1009.4.2....
-
11B-1009.5.3 Height
The height of the transfer platform shall comply with Section 11B-1009.4.2....
-
11B-411.3.3.1 Height
The height of the reopening device shall comply with Section 11B-407.3.3.1....
-
11B-704.4.1 Height
Advisory 11B-704.4.1 Height....
-
M305.2.1 Location (Section-by-Section Analysis)
This commenter noted that an adjacent transfer support would be more effective, but would conflict with the provider expectations of bed and stretcher side rails....
-
5.8.2.5 Toe Height Recommendation
recommended that the toe height be set to 18 inches (when the breast platform is at the 34 inch height discussed above)....
-
5.8.3.1 Breast Platform Height
5.8.3.1 Breast Platform Height. The height of the top of the breast platform should be decreased to 26 inches above the floor....
-
[F] 907.4.2.2 Height
[F] 907.4.2.2 Height. ...
-
M305.2.2 Length (Section-by-Section Analysis)
The second exception applies to transfer supports on imaging bed surfaces of more than 24 inches in width, such as large x‐ray tables, where the support is likely to be used in the latter...
-
SEAT HEIGHT MEASUREMENT DETAIL
SEAT HEIGHT MEASUREMENT DETAIL Regardless of measurement technique used, the height is measured at the highest point of the seat, inclusive of bolsters, with the foam in an uncompressed...
-
IDeA Center: Transferring from Wheeled Mobility to MidMark's Barrier-Free Examining Table
This video produced by the Institute for Human Centered Design represents an abbreviated study of five User/Experts with different functional conditions transferring on and off of a...
-
3.2 Getting on the Table
The height of exam tables was the most commonly reported complaint.4 A survey of approximately 400 Californians with disabilities found exam tables were inaccessible to 69% of wheelchair...
-
Check-Out Aisles and Sales and Service Counters
Where the counter is a single-height counter, this requirement applies across the entire depth of the counter top....
-
M303.2.4.2.2 Height
Between 9 inches (230 mm) and 27 inches (685 mm) above the floor, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for every 6 inches (150 mm) in height...
-
11B-1009.4.2 Height
The height of the transfer wall shall be 16 inches (406 mm) minimum and 19 inches (483 mm) maximum measured from the deck....
-
11B-1009.4.2 Height
The height of the transfer wall shall be 16 inches (406 mm) minimum and 19 inches (483 mm) maximum measured from the deck....
-
Protocol C Heights Obtained
For the maximum height transfers HERL's percentile heights were slightly higher for the 25th and 75th percentiles than the NDVWSC heights....
