(a) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Cabinets under lavatories are acceptable provided the bathroom...
Search Results "Wing Wall"
Filters
Commonly Searched Documents
-
7(2)(a)
-
Extensions
Handrails that are not continuous must have horizontal extensions at both the top and bottom of the ramp at least 12 inches long that are rounded or returned smoothly to walls, posts, or...
-
11B-404.2.4.3 Recessed doors and gates
A door can be recessed due to wall thickness or because of the placement of casework and other fixed elements adjacent to the doorway....
-
11B-604.6 Flush controls
To prevent causing injury or imbalance, the plumbing can be located behind walls or to the side of the toilet; or if approved by the local authority having jurisdiction, provide a toilet...
-
TABLE 601 FIRE-RESISTANCE RATING REQUIREMENTS FOR BUILDING ELEMENTS (hours)
HT Ad B Structural framea Including columns, girders, trusses 3b 2b 1 0 1 0 HT 1 0 Bearing walls...
-
903.3.1.1.1 Exempt locations
Generator and transformer rooms separated from the remainder of the building by walls and floor/ceiling or roof/ceiling assemblies having a fire-resistance rating of not less than 2 hours...
-
Accessible Pathway & Corridor: Minimum Clear Floor Space Required for 360-degree Turn
These data are based on measurements of wheeled mobility users performing 360-degree turns within an enclosed square space built with mock walls....
-
11B-608.2.1 Transfer type shower compartments
Clearance of 36 inches (914 mm) wide minimum by 48 inches (1219 mm) long minimum measured from the control wall shall be provided....
-
804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
Toilet Rooms-Banquet Area
The toilet centerline of the men's toilet room is 19" from the side wall instead of the required 18". See Standards § 4.16.2....
-
Furniture in Space with Clutter
Freestanding furniture is going to be just as much an issue to navigate through as the architectural walls and the space....
-
J1
If the drinking fountain is a wall-mounted unit, is there clear floor space at least 30 inches wide (36 inches if it is in an alcove) x 48 inches long in front of the drinking fountain and...
-
Protruding Objects [4.31.4]
Protruding Objects [4.31.4] Wall- or post-mounted pay phones and enclosures, due to their location above the standard sweep of canes (i.e., 27 inches high from the floor), can be a hazard...
-
Recessed Doors and Gates [§404.2.4.3]
Recessed Doors and Gates [§404.2.4.3] Thick walls, casework, shelving, columns and other elements can cause doors or gates to be recessed....
-
1133A.4.1, Item 4
Finished flooring shall be extended to the wall beneath the sink and work surface. Exceptions: 1....
-
804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
Aquatic Recreation Facilities
access to the water is limited to one area and where everyone gets in and out at the same place, must provide at least one accessible means of entry, no matter how many linear feet of pool wall...
-
4.1.4(13) UTILITY AND MISCELLANEOUS
Utility and miscellaneous occupancies include, among others, accessory buildings and structures, such as: Facilities Fences over 6 ft. high Tanks Cooling towers Retaining walls...
-
4.34.5.5(2) Seat
The seat shall be on the wall opposite the controls. The structural strength of seats and their attachments shall comply with 4.26.3....
-
Horizontal Exits [IBC §1021 (2003), §1005.3.5 (2000)]
compartmentalizes a building allowing occupants to exit the area containing the origin of a fire into another portion of the building that is protected by fire-resistance-rated assemblies (doors, walls...
-
1134A.6, Item 1.2
water closet may project a maximum of 12 inches (305 mm) into the opening, provided that a minimum of 36 inches (914 mm) clear space is maintained between the water closet and the shower wall...