[See subsections ...]
Search Results "Bus Ramp"
Commonly Searched Documents
-
§ 38.155 Interior circulation, handrails and stanchions
-
B. Restrooms
B. Restrooms. The following is provided to assist manufacturers and designers to create restrooms which can be used by people with disabilities. These specifications are derived from...
-
§ 38.153(a)
(a) Floor surfaces on aisles, step treads and areas where wheelchair and mobility aid users are to be accommodated shall be slip-resistant.
-
§ 38.159(b)(3) Emergency operation
(3) Emergency operation. The lift shall incorporate an emergency method of deploying, lowering to ground level with a lift occupant, and raising and stowing the empty lift if the...
-
§ 38.159(b)(2) Controls
(2) Controls—
-
§ 38.159(b)(12) Use by standees
(12) Use by standees. Lifts shall accommodate persons using walkers, crutches, canes or braces or who otherwise have difficulty using steps. The platform may be marked to indicate a...
-
§ 38.159(b)(1) Design load
(1) Design load. The design load of the lift shall be at least 600 pounds (2665 N). Working parts, such as cables, pulleys, and shafts, which can be expected to wear, and upon which...
- How to Determine the Total Rise of a Ramp Run
-
§ 38.125(c)(3) Ramp threshold
(3) Ramp threshold....
-
§35.150(d)(2)
(2) If a public entity has responsibility or authority over streets, roads, or walkways, its transition plan shall include a schedule for providing curb ramps or other sloped areas where...
-
§ 35.150(d)(2)
(2) If a public entity has responsibility or authority over streets, roads, or walkways, its transition plan shall include a schedule for providing curb ramps or other sloped areas where...
-
§ 38.95(c)(3) Ramp threshold
(3) Ramp threshold....
-
Section 37.121 Requirement for Comparable Complementary Paratransit Service
This requirement applies to light and rapid rail systems as well as to bus systems, even when rail and bus systems share all or part of the same service area....
-
4.8.4* Landings
Ramps shall have level landings at bottom and top of each ramp and each ramp run. Landings shall have the following features:...
-
DSA Drawing 11B-406-7C Curb Ramp Adjoining a Parking Access Aisle next to a Curb and Gutter (2016 CBC)
Requires the Premium User plan or above. (Login or upgrade your account!)
- Figure 406.6 Diagonal or Corner Type Curb Ramps – Drawing from the U.S. Access Board
-
§ 37.42(f)
vertical gap is more than 5/8 inch, measured when the vehicle is at rest, the horizontal and vertical gaps between the car floor and the boarding platform must be mitigated by a bridge plate, ramp...
-
5 [§ 4.7.2]
5 [§ 4.7.2] The transitions on and off the curb ramp are the points where the gutter meets the bottom of the ramp and where the top of the ramp meets the sidewalk....
-
Is there a minimum distance between changes in level?
Ramps and curb ramps, which must be used to span vertical changes greater than ½”, must have level landings and clearances at the tops and bottoms of each run to provide adequate separation...
-
Doorways [4.8.4]
Recommendation: Ramps and doors should be configured to facilitate wheelchair maneuvering and to prevent open doors from obstructing ramp openings (important along egress routes)....
-
9.a [§ 4.7.5]
9.a [§ 4.7.5] If the sidewalk at the top of the ramp (“x” in the illustration) is 48 inches wide or more, answer this question....
-
R304.3.2 Running Slope
The running slope of the curb ramp shall be in-line with the direction of sidewalk travel....
- Madden Manufacturing Round Handrail (ADA Compliant)
- EZ-ACCESS Transitions® Modular Entry Mat