Q7: Is a curb ramp required for a sidewalk that is not made of concrete or asphalt?...
Search Results "Boarding Ramp"
-
Q7: Curb Ramp for a Sidewalk that is Not Made of Concrete or Asphalt
-
Width [4.7.3] and Surface [4.7.4]
The minimum clear width of a curb ramp is 36 inches, exclusive of flared sides....
- Alumi-Guard Handrail
- Simplified Building Concepts ADA Handrail
-
T204.2 Doorways with Lifts, Ramps or Bridgeplates
Doorways with lifts or ramps shall comply with T502.2....
-
§ 38.95(c)(4) Ramp barriers
(4) Ramp barriers. Each side of the ramp or bridge plate shall have barriers at least 2 inches high to prevent mobility aid wheels from slipping off....
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
EZ-ACCESS The Gateway™ Solid Surface Portable Ramp Video
Requires the Registered User plan or above. Login!
-
F. What are Pedestrian Crossings and Where Must Curb Ramps be Provided?
Where and when curb ramps are required depends on the location and the age of streets and sidewalks....
-
5. Medical Diagnostic Equipment
From the Board’s website: “The Board has issued accessibility standards for medical diagnostic equipment under section 510 of the Rehabilitation Act....
-
§ 38.113(d)(1) Requirements
Cars which provide level-boarding in stations with high platforms shall be coordinated with the boarding platform or mini-high platform design such that the horizontal gap between a car...
-
7 [§ 4.7.8]
7 [§ 4.7.8] Curb ramps must be located where they will not be obstructed by parked vehicles....
-
§ 38.83(c)(3) Ramp threshold
(3) Ramp threshold....
-
Top Landings
Commenters advised that landings should be specified at the top of curb ramps. Response....
-
§ 38.159(c)(3) Ramp threshold
(3) Ramp threshold. The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch (6.5 mm)....
-
Ramps M303:3.3, 3.3.1, 3.3.2
ramped surface...
-
Section 810.2.2
Section 810.2.2 The Department recognizes that there will be some situations in which the full dimensions of a bus boarding and alighting area complying with the §810.2.2 may not be able...
-
11B-247.1.2.1 Platform edges
Platform boarding edges shall have detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.1. ...
-
§ 38.111(b)(2)
(2) Where level boarding is structurally or operationally impracticable, intercity rail cars shall comply with §38.125....
-
11B-247.1.2.1 Platform edges
Platform boarding edges shall have detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.1....
-
11B-247.1.2.1 Platform edges
Platform boarding edges shall have detectable warnings complying with Sections 11B-705.1.1 and 11B-705.1.2.1....
-
§ 38.111(b)(1)
(1) Unless structurally or operationally impracticable, intercity rail cars shall comply with §38.113(d) of this part for level boarding....
-
d-vi
Does the ramp have a level landing that is at least 60 inches long at the top and bottom of each ramp section or where the ramp changes direction?...
-
General (R304.1) (Section-by-Section Analysis)
General (R304.1) (Section-by-Section Analysis) Curb ramps are ramps that are cut through or built up to the curb (see R105.5)....