Lists of stations, routes and destinations served by the station which are located on boarding areas, platforms, or mezzanines shall comply with Section 11B-703.5 _|Signs; Visual...
Search Results "Support Rail"
Filters
Commonly Searched Documents
-
11B-810.6.2 Routes and destinations
-
11B-810.6.2 Routes and destinations
Lists of stations, routes and destinations served by the station which are located on boarding areas, platforms, or mezzanines shall comply with Section 11B-703.5. At least one...
-
M305.2.1 Location
Transfer supports shall comply with M305.2.1.1 or M305.2.1.2 and shall be located 1 ½ inches (38 mm) maximum measured horizontally from the plane defined by the nearest edge of the transfer...
-
M305.2.6 Gripping Surface
Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
M305.2.3 Fittings
Transfer supports shall not rotate within their fittings....
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The proposed rule did not provide specific requirements for the cross section of transfer supports....
-
M305.2.8 Fittings
Transfer supports shall not rotate within their fittings when in place for transfer....
-
M305.2.7 Clearance
Clearance between the transfer support gripping surface and adjacent surfaces or obstructions shall be 1 ½ inches (38 mm) minimum....
-
M305.2.4 Cross Section
Transfer supports shall have a cross section complying with 305.2.4.1 or 305.2.4.2....
-
M305.2.5 Surface Hazards
Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges....
-
Service Animal Issues
Another important issue that a number of commenters raised concerned “emotional support animals.”...
-
§ 38.125(b)(6) Platform surface
(6) Platform surface. The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant. The lift platform shall have a minimum clear width of...
-
M305.2.1 Location
Transfer supports shall be located within reach of the transfer surface and shall not obstruct transfer onto or off of the surface when in position....
-
Conclusion
During this second phase of the independent wheelchair transfer study, platform transfers with and without grab-bars and a backrest and two-step transfers were evaluated. The study...
-
Hill-Rom Likorall™ Overhead Lift, Traverse with Upright Supports
Video shows animation of how the Likorall™ Overhead Lift with Traverse Rail with upright supports is assembled and used....
-
Service and Companion Animal Owners: Know Your Rights!
Service and Companion Animal Owners Service and companion animals can help people with disabilities go about their daily lives. Unfortunately, there’s still a lot of confusion...
-
Implication for Standards and Design
Each phase involved a highly customized transfer station iteratively developed with scientific, expert and consumer input to support the goals of the project. ...
-
T504 Passenger Access Routes
[See subsections ...]
-
CHAPTER 5: DOORWAYS, CIRCULATION PATHS AND FARE COLLECTION DEVICES
[See subsections ...]
-
CHAPTER 4: BOARDING AND ALIGHTING
[See subsections ...]
-
§ 37.43(a)(1)
(1) When a public entity alters an existing facility or a part of an existing facility used in providing designated public transportation services in a way that affects or could...
-
§ 38.123(a)(1)
(1) The minimum clear floor area shall be 35 inches by 60 inches. Permanently installed fixtures may overlap this area a maximum of 6 inches, if the lowest portion of the fixture is...
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed transfer surface...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports....
