[See subsections ...]
Search Results "Grab Bar Height"
Commonly Searched Documents
-
1018 Beach Access Routes
-
Technical Requirements [1018 and 1018.1, Exception 3]
The technical requirements for beach access routes include specific provisions for connections, the surface, clear width, obstacles, openings, running slope, cross slope, resting...
-
F248 Beach Access Routes
[See subsections ...]
-
1018 Beach Access Routes
[See subsections ...]
-
1018 Beach Access Routes
[See subsections ...]
-
F248 Beach Access Routes
[See subsections ...]
-
Height: ADA Standard Section 1009.4.2
The height of the transfer wall shall be 16 inches (405 mm) minimum and 19 inches (485 mm) maximum measured from the deck....
-
Initial Measures and Transfer Setup
The device seat to floor height was measured as the linear distance between the front of the seat, center-line point on top of the cushion (if present) and the floor (Figure 3 left). ...
- Medical Accessibility LLC
-
Mounting Height and Location
Section 703.4 covers the mounting height and location of signs with tactile characters....
-
Height: ADA Standard Section 1008.3.1.2
The height of transfer platforms shall be 11 inches (280 mm) minimum and 18 inches (455 mm) maximum measured to the top of the surface from the ground or floor surface....
- Smith System Husky Square Activity Table
- Smith System Trespa Planner Science Table 30″ Deep 11288
- Access Board: Alternate Type Roll In Shower Stalls
-
1005.2.1 Height
1005.2.1 Height. At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
11B-602.4 Spout height
Spout outlets shall be 36 inches (914 mm) maximum above the finish floor or ground.
-
11B-602.4 Spout height
Spout outlets shall be 36 inches (914 mm) maximum above the finish floor or ground.
-
4.7.9.3 Height
The counter or rim of the sink shall be no more than 34 inches (865 mm) above the floor or ground. Water spouts must be 28 inches (710 mm) minimum and 36 inches (915 mm) maximum...
-
703.4.1 Height Above Finish Floor or Ground
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60...
-
Jamb Signage
...are all elevator jambs provided with signs placed on both sides designating the floor with 2" minimum height raised letters and Braille characters centered at 60" above the finish floor...
-
National Network of ADA Centers
of a low height transfer number....
-
A5.1 General
This section requires that where such a dining counter is provided, a portion of the counter shall be at the required accessible height....