Exceptions: Drive-up only automatic teller machines and fare machines shall not be required to comply with Sections 11B-309.2 and 11B-309.3....
Search Results "Built-Up Curb Ramp"
-
11B-707.3 Operable parts
-
RV Parking Spaces Within Camping Units With Mobility Features and RV Pull-Up Spaces at Dump Stations [F244.2.3.2.1 and F244.4]
RV parking spaces within camping units with mobility features and RV pull-up spaces at dump stations must comply with the technical requirements for width, surface, and slope of RV spaces...
- Slope : Intercept
-
Exterior Routes
. 11B-303.4 Abrupt changes in level exceeding 4 inches, vertical dimension shall be identified by warning curb. 11B-303.5...
-
Exterior Routes
. 11B-303.4 Abrupt changes in level exceeding 4 inches, vertical dimension shall be identified by warning curb. 11B-303.5...
-
A. Question 1: Applicability of Section 904.4.1’s Exception
If, however, Defendants’ transaction counter is equal to or longer than 36 inches as built, Defendants still have complied with 904.4.1 for the reasons explained below.2 2 The submissions...
-
§ 38.23(c)(1) Design load
Ramps 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based...
-
235.3 Boarding Piers at Boat Launch Ramps
235.3 Boarding Piers at Boat Launch Ramps....
-
11B-707.3 Operable parts
Drive-up only automatic teller machines and fare machines shall not be required to comply with Sections 11B-309.2 and 11B-309.3. 2....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
Scoping [4.1.3(12)]
Scoping [4.1.3(12)] ADAAG covers fixed or built-in storage facilities in public or common use spaces and requires access to at least one of "each type."...
-
1.9.1.1 Application
Publicly funded buildings, structures, sidewalks, curbs and related facilities shall be accessible to and usable by persons with disabilities as follows: Advisory 1.9.1.1 Application...
-
1.9.1.1 Application
Publicly funded buildings, structures, sidewalks, curbs and related facilities shall be accessible to and usable by persons with disabilities as follows: Advisory 1.9.1.1 Application...
-
1.9.1.1 Application
Publicly funded buildings, structures, sidewalks, curbs and related facilities shall be accessible to and usable by persons with disabilities as follows: Advisory 1.9.1.1 Application...
-
Height: ADA Standard Section 902.4.2
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (760 mm) maximum above the finish floor or ground.
-
Height: ADA Standard Section 902.3
The tops of dining surfaces and work surfaces shall be 28 inches (710 mm) minimum and 34 inches (865 mm) maximum above the finish floor or ground.
-
11B-902.3 Height
The tops of dining surfaces and work surfaces shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground.
-
11B-902.3 Height
The tops of dining surfaces and work surfaces shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground.
-
11B-405.10 Wet conditions
Landings subject to wet conditions shall be designed to prevent the accumulation of water.
-
11B-405.10 Wet conditions
Landings subject to wet conditions shall be designed to prevent the accumulation of water.
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
4.7 Utilities including Water Hydrants at Recreation Sites
[See subsections ...]
-
1.1.1
ADAAG and accessibility experts recommend that ramps be built with the least slope possible but in no case should a ramp exceed a 1:12 slope (except for curb ramp flares, and other approved...