1.9.1.1.4 All existing publicly funded buildings and facilities when alterations, structural repairs or additions are made to such buildings or facilities....
Search Results "Altered Element"
-
1.9.1.1.4
-
1.9.1.1.4
1.9.1.1.4 All existing publicly funded buildings and facilities when alterations, structural repairs or additions are made to such buildings or facilities....
-
New Construction
Alterations....
-
4.1.6(4)(c)
(ii) Where existing shaft or structural elements prohibit strict compliance with 4.10.9, then the minimum floor area dimensions may be reduced by the minimum amount necessary, but in no...
-
ABA CHAPTER 2: SCOPING REQUIREMENTS
[See subsections ...]
-
4.1.6(3)(d)(ii)
(ii) If existing thresholds are 3/4 in high or less, and have (or are modified to have) a beveled edge on each side, they may remain.
-
4.1 Minimum Requirements
[See subsections ...]
-
4.1 MINIMUM REQUIREMENTS
4.1 MINIMUM REQUIREMENTS.
-
11B-206.2.3.1 Stairs and escalators in existing buildings
In alterations and additions, where an escalator or stair is provided where none existed previously and major structural modifications are necessary for the installation, an accessible route...
-
11B-206.2.3.1 Stairs and escalators in existing buildings
In alterations and additions, where an escalator or stair is provided where none existed previously and major structural modifications are necessary for the installation, an accessible route...
-
11B-206.2.3.1 Stairs and escalators in existing buildings
In alterations and additions, where an escalator or stair is provided where none existed previously and major structural modifications are necessary for the installation, an accessible route...
-
11. Outside of the Service Area or Operating Hours
This request would not be a reasonable modification because it would constitute a fundamental alteration of the entity's service....
-
Section 36.405 Alterations: Historic Preservation (Section-by-Section Analysis)
Section 36.405 Alterations: Historic Preservation (Section-by-Section Analysis) In the 1991 rule, the Department provided guidance on making alterations to buildings or facilities that...
-
b) Applicability
In theory, a Building Code remains applicable throughout the life and operation of a building or other element of the built environment -- see also subsequent discussions about changes and...
-
Applicability
In theory, a Building Code remains applicable throughout the life and operation of a building or other element of the built environment -- see also subsequent discussions about changes and...
-
12204(c)(3) Other sites
.-- With respect to alterations of buildings or facilities designated as historic under State or local law, the guidelines described in paragraph (1) shall establish procedures equivalent...
-
12204(c)(3) Other sites
(3) Other sites With respect to alterations of buildings or facilities designated as historic under State or local law, the guidelines described in paragraph (1) shall establish procedures...
-
11B-202.3 Alterations
Where existing elements or spaces are altered, each altered element or space shall comply with the applicable requirements of Division 2, including Section 11B-202.4....
-
VALUATION THRESHOLD
Materials (ca.gov) ◼ ETA Editor's Note From DSA: The valuation threshold is the annually-updated figure used when determining path of travel accessibility requirements in alterations...
-
VALUATION THRESHOLD
. ◼ ETA Editor's Note From DSA: The valuation threshold is the annually-updated figure used when determining path of travel accessibility requirements in alterations, additions...
-
101.1 General
This document contains scoping and technical requirements for accessibility to sites, facilities, buildings, and elements by individuals with disabilities....
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
2. Effective Date
On March 15, 2012, compliance with the 2010 Standards will be required for new construction and alterations and barrier removal....