The guidelines cover the minimum scoping and technical requirements for various spaces and elements in the public right-of-way, such as pedestrian access routes, which ensure the accessibility...
Search Results "Clear Floor Space"
Filters
Commonly Searched Documents
-
1. Public Rights-of-Way
-
Clarification on Standard Roll-In Shower Compliance
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
V. ENSURING EQUAL ACCESS TO CUSTOMERS WITH DISABILITIES
., removing snow and ice from accessible parking spaces and other outdoor accessible features). d. Training for New Employees....
-
Elevator Car Controls
The advisory committee recognized a potential adverse impact of a lower maximum height on elevators with panels that must have a large number of buttons in a limited amount of space and...
-
11B-222.1 General
Some designs include private changing facilities that are close to core areas of the facility, while other designs use space more economically and provide only group dressing facilities....
-
1117B.5.6
Dots shall be 1/10 inch (2.54 mm) on center in each cell with 2/10-inch (5.08 mm) space between cells, measured from the second column of dots in the first cell to the first column of dots...
-
R302.3.2 Shared Use Paths
access routes to be 4 feet wide minimum, except R302.3.1 would require pedestrian access routes within medians and pedestrian refuge islands to be 5 feet wide minimum to allow for passing space...
-
Accessible Amusement Rides
Other provisions contained in ADAAG address elements commonly found at an amusement park or theme park, such as accessible vehicle parking spaces, exterior accessible routes, and toilet...
-
5.5.1 Armrest Provision for M302
Armrests serve a similar function, and occupy the same physical space, as the transfer supports as described in the NPRM....
-
3. If I comply with the California accessibility requirements, am I in compliance with ADA?
Under the CBC, however, if you change the use of a room or space without submitting for a permit, the accessibility requirements of the CBC still applies....
-
4.1.4(4) ASSEMBLY
A room or space used for assembly purposes by less than fifty (50) persons and accessory to another occupancy shall be included as a part of that major occupancy....
-
PRIORITIES
These measures include, for example, installing an entrance ramp, widening entrances, and providing accessible parking spaces....
-
11B-222.1 General
Some designs include private changing facilities that are close to core areas of the facility, while other designs use space more economically and provide only group dressing facilities....
-
11B-222.1 General
Some designs include private changing facilities that are close to core areas of the facility, while other designs use space more economically and provide only group dressing facilities....
-
11B-215.1 General
Unlike audible alarms, visible alarms must be located within the space they serve so that the signal is visible....
-
11B-101.2 Reserved.
toilet seat; 16) Installing a full-length bathroom mirror; 17) Repositioning the paper towel dispenser in a bathroom; 18) Creating designated accessible parking spaces...
-
American Standard Yorkville 1.6 gpf Right Height Elongated Pressure Assisted Toilet
Floor-mounted, back-outlet toilet combination bowl and tank less seat Pressure-assisted siphon jet action EverClean® Surface Elongated 16-1/2" high bowl for accessible...
-
Symmetry Vertical Platform Lift VPC-SL
platform (when not installed within a runway enclosure) Alarm and emergency stop switch Grab rail Landing interlocks keep door locked when the lift is on another floor...
-
AJW Architectural Products UG2-Railing UG2X-Y108 108" Concealed Snap Flange, 1.25" Diameter, Peened Grip - Configuration Y
Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates....
-
AJW Architectural Products UG3-A Series UG3-A12 12" Concealed Snap Flange, 1.5" Diameter Grab Bar - Configuration A
Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates....
-
AJW Architectural Products UG130-A Series UG130-A12 12" Exposed Flange, 1.5" Diameter Grab Bar - Configuration A
Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates....
-
AJW Architectural Products UG30-Railing UG30X-Y108 108" Concealed Set Screw Flange, 1.5" Diameter, Peened Grip - Configuration Y
Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates....
-
AJW Architectural Products UG20-Railing UG20X-Y108 108" Concealed Set Screw Flange, 1.25" Diameter, Peened Grip - Configuration Y
Recommended mounting heights for grab bars are 33" - 36" centerline above finished floor. All mounting of grab bars when possible should have in wall mounting back plates....
