This is the current industry standard for TTY signals (also known as Baudot) at the PSTN interface....
Search Results "Pedestrian Signal"
-
410.6.3.1 PSTN (Section-by-Section Analysis)
-
G. What are Detectable Warnings, Why are They Required, and Where Must They be Provided?
Detectable warnings are intended to function much like stop signs for pedestrians who are blind or have low vision....
-
11B-233.3.1.2.6.4 Test number three, unusual characteristics test
The original site characteristics result in a difference in finished grade elevation exceeding 30 inches (762 mm) and 10 percent measured between an entrance and all vehicular or pedestrian...
-
CURB CUT
An interruption of a curb at a pedestrian way, which separates surfaces that are substantially at the same elevation....
-
MARKED CROSSING
A crosswalk or other identified path intended for pedestrian use in crossing a vehicular way....
-
TRANSITION PLATE
[DSA-AC] A sloping pedestrian walking surface located at the end(s) of a gangway....
-
Site Improvement
Landscaping, paving for pedestrian and vehicular ways, outdoor lighting, recreational facilities, and the like, added to a site....
-
SITE IMPROVEMENT
Landscaping, paving for pedestrian and vehicular ways, outdoor lighting, recreational facilities, and the like, added to a site....
-
Trail
A pedestrian route developed primarily for outdoor recreational purposes (U.S. Access Board, 2009)....
-
Marked Crossing
A crosswalk or other identified path intended for pedestrian use in crossing a vehicular way....
-
Pulse Duration and Flash Rate
Pulse duration is the interval of the flash between signal build-up and decay and is limited as specified so that the signal is not temporarily blinding....
-
Mounting Height
Mounting Height ADAAG specifies a signal height 80 inches above the highest floor level within the space or 6 inches below the ceiling, whichever is lower....
-
3.1 Selecting the Appropriate Microphone
In order to ensure adequate signal strength and maximum speech intelligibility, microphone specifications should meet or exceed the specifications of the rest of the system components....
-
R211.1 General
Where audible sign systems and other technologies are used to provide information equivalent to the information contained on pedestrian signs and transit signs, the signs are not required...
-
206.3 Location
This means that circulation paths, such as vehicular ways designed for pedestrian traffic, walks, and unpaved paths that are designed to be routinely used by pedestrians must be accessible...
-
ACCESS AISLE
[DSA-AC] An accessible pedestrian space adjacent to or between parking spaces that provides clearances in compliance with this code....
-
ACCESS AISLE
[DSA-AC] An accessible pedestrian space adjacent to or between parking spaces that provides clearances in compliance with this code....
-
R304.1 General
• Parallel curb ramps have a running slope that is in-line with the direction of sidewalk travel and lower the sidewalk to a level turning space where a turn is made to enter the pedestrian...
-
§ 1194.23(j)
Technologies which use encoding, signal compression, format transformation, or similar techniques shall not remove information needed for access or shall restore it upon delivery....
-
A4.1.3(9)
A4.1.3(9) Supervised automatic sprinkler systems have built in signals for monitoring features of the system such as the opening and closing of water control valves, the power supplies for...
- Inpro Corporation JointMaster® DR Series Seal Expansion Joint Systems
-
THIRD CAUSE OF ACTION
The City's pedestrian right of way is a "place of public resort, accommodation, assemblage, or amusement" within the meaning of the Washington Law Against Discrimination, Wash. Rev....
-
2.1.1 General Description
The audio signals from the sound source (usually a microphone, though other audio sources can be accommodated) are amplified and sent as an alternating electric current through the wire...
-
8.2.2 Stimuli
The recorded signals were then redigitized and stored onto a computer disk for presentation during the experiment....