A: Yes, if those policies and procedures do not implement the Amendments Act's new legal standards....
Search Results "TAS: Texas Accessibility Standards"
Filters
Commonly Searched Documents
-
Q5: Should a school district revise its policies and procedures regarding the determination of coverage and provision of services under Section 504 and Title II?
-
The National Highway Traffic Safety Administration’s (NHTSA) motor vehicle safety regulations require that a wheelchair lift be tested to withstand a 600-pound load. If the manufacturer states that the design load is 800 pounds, can the transportation operator limit actual use to 600 pounds for safety reasons?
The NHTSA safety standards and the DOT ADA regulations were designed to complement each other....
-
407.7 Color (Section-by-Section Analysis)
The proposed section is the same as existing 508 Standards § 1195.25(g), and is consistent with 255 Guidelines § 1193.41(c)....
-
E102.5 Internet Engineering Task Force (IETF)
Copies of the referenced standard may be obtained from the Internet Engineering Task Force (http://www.ietf.org/)....
-
4.10.12(2)
All control buttons shall be designated by Braille and by raised standard alphabet characters for letters, arabic [sic] characters for numerals, or standard symbols as shown in Fig. 23(a...
-
4.10.12(2)
All control buttons shall be designated by raised standard alphabet characters for letters, arabic characters for numerals, or standard symbols as shown in Fig. 23(a), and as required in...
-
11B-221.2.1.1 General seating
5 301 to 500 6 501 to 5000 6, plus 1 for each 100, or fraction thereof, between 501 through 5000 [2010 ADA Standards...
-
11B-502.1 General
Where parking spaces are marked with lines, width measurements of parking spaces and access aisles shall be made from the centerline of the markings....
-
References
Accessibility Guidelines for Recreation Facilities, (2002). 2. Accessible amusement rides - a summary of accessibility guidelines for recreation facilities....
-
II. Recommendations of Diagnostic Imaging Equipment Manufacturers on Transfer Surface Low Height
During the meetings of the Advisory Committee, there was no compelling evidence presented in support of a minimum transfer low height of 17 inches as the new standard for access....
-
Evaluation of transfers
These design parameters of the standard should be revised to reflect the setup of current WMD users as devices have changed since the standards were created in the 1970s....
-
Federal Highway Administration (FHWA): ADA/Section 504 Programs
Laws and regulations require accessible planning, design, and construction to integrate people with disabilities into mainstream society....
-
Allegion Schlage S-Series Mechanical Locks with Tubular Interconnect
The intent of ADA is that owners of certain types of buildings must remove barriers and provide people with disabilities with access equal to, or similar to, that available to the general...
-
B. How Does a TTY Work?
Computers with TTY modems generally operate in American Standard Code for Information Interexchange (ASCII), an electronic “language.”...
-
Shower Compartment Seats: ADA Standard Section 610.3
Section 610.3 covers the current ADA Standards for shower compartment seats.
-
c. Transfer Surface Size for Diagnostic Equipment Used by Patients in the Supine, Prone, or Side-lying Position
D 610.3.1) and the ANSI/AAMI HE 75 which notes that a standard examination table is 27 inches wide and a bariatric table is approximately 30 to 32 inches wide and recommends wider surfaces...
-
Sec. 469.059(a)
(a) The department shall continue to monitor a complaint made under Section 51.252, Occupations Code, that alleges that a building or facility is not in compliance with the standards and...
-
§ 36.406(f) Assembly areas
Assembly areas subject to the proposed standards shall comply with the provisions applicable to assembly areas, including, but not limited to, sections 221 and 804. ...
-
702.4 Human Factors and Ergonomics Society (HFES)
Copies of the referenced standard may be obtained from the Human Factors and Ergonomics Society, P.O....
-
702.5 Institute of Electrical and Electronics Engineers (IEEE)
Copies of the referenced standard may be obtained from the Institute of Electrical and Electronics Engineers, 10662 Los Vaqueros Circle, P.O....
-
§ 35.151(g) Assembly areas
Assembly areas subject to the proposed standards shall comply with the provisions applicable to assembly areas, including, but not limited to, sections 221 and 804. ...
-
e-iv
[ADA Standards § 4.10.12 (3)] Yes No...
-
d-vi
[ADA Standards § 4.8.4] Yes No...
-
M6
[ADA Standards §§ 4.22.3; 4.2.3] Yes No...
