Exception: Slopes not steeper than 1:48 shall be permitted....
Search Results "Counter Slope"
Filters
Commonly Searched Documents
-
11B-305.2 Floor or ground surfaces
-
305.2 Floor or Ground Surfaces
[ECTCR UFAS 4.2.4.3] EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
1133A.4.1, Item 2
2. Base cabinets directly under sinks and work surfaces shall be removable as required in Section 1133A.3.
-
Miniature Golf Facilities
Word Fillable Form (1.0MB) Word Non-Fillable Form (1.0MB) PDF Non-Fillable Form (0.5MB)
-
1.1.16 Alternate measurement tools
Measure running slope along the same lines of measurements as stated in Section 1.1.13 Although the F - number system can be used to measure surface flatness for smooth surfaces it requires...
-
4.2 Physical Accessibility Barriers and Solutions
area makes it difficult to see staff and sign in Place sign check-in equipment on a side table or use a clipboard Install a lower countertop or lower a section of the existing counter...
-
A4.32.4 HEIGHT OF WORK SURFACES
The great variety of heights for comfort and optimal performance indicates a need for alternatives or a compromise in height if people who stand and people who sit will be using the same counter...
-
1133A.7, Item 1
1. The knee and toe space shall be clear and unobstructed, or removable base cabinets in compliance with Section 1133A.3 shall be provided.
-
1133A.7, Item 1
1. The knee and toe space shall be clear and unobstructed, or removable base cabinets in compliance with Section 1133A.3 shall be provided.
-
206 and Chapter 4 Accessible Routes
[See subsections ...]
-
Polling place violations that can be remediated with temporary measures
maximum slope allowed of 1:48 (1991 ADA Stds 4.6.3; 2010 ADA Stds 502.4)....
-
1(2)(a)(ii) Site analysis test
entrance served by an accessible route can be established by the following steps: (A) The percentage of the total buildable area of the undisturbed site with a natural grade less than 10% slope...
-
Rough Grade Site Inspection
Verify that drainage, drainage swales, catch basins and grates do not violate slope or surface requirements along accessible routes, accessible parking and access aisles, etc....
-
Rough Grade Site Inspection
Verify that drainage, drainage swales, catch basins and grates do not violate slope or surface requirements along accessible routes, accessible parking and access aisles, etc....
-
11B-305.2 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved....
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
-
Allen Face F-Meter® Rolling Floor Profiler
The F-Meter® is the finest floor profiling instrument ever made. Pulled manually across the floor, the F-Meter® can measure up to 2500 linear feet (5,000 point elevation readings!)...
-
The Dipstick® Floor Profiler Tool
Advantages The Dipstick Auto-Read Floor Profiler is a totally integrated data collection instrument that provides a fast and accurate method of measuring floors for flatness and...
-
Example 1: With Cooking Facilities
Example The break room shown in the illustration has a counter, sink, built-in cooking facility (microwave), and storage....
-
502.4 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted. ...
-
804.3 Kitchen Work Surface (Exception)
804.3 Kitchen Work Surface (Exception) This section requires at least one work surface to be provided at kitchen counters in residential dwelling units required to provide mobility features...
-
1002.2 Accessible Routes
In load or unload areas and on amusement rides, where compliance with 405.2 is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum. 2....
