6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
Search Results "Residential Dwelling Unit for Sale"
Filters
Commonly Searched Documents
-
1132A.3, Item 6
-
1133A.7, Item 2
2. The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance.
-
1133A.2.1, Item 2
2. U-shaped kitchens, designed with a cooktop or sink located at the base of the U, which provides a knee and toe space in accordance with Section 1133A.7 to allow for a forward...
-
11B-809.10.6.4 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm)...
-
1133A.7 Knee and toe space
Knee and toe space, when required by Section 1133A, shall comply with Section 1138A.2 and the following: The knee and toe space shall be clear and unobstructed, or removable...
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor. Where towel bars are provided they shall be...
-
11B-809.10.8.6 Controls
Faucet controls and operating mechanisms shall comply with Section 11B-309.4.
-
206.6 Elevators
Elevators complying with 408 or 409 shall be permitted in multi-story residential dwelling units....
-
Figure 904.4 (Exception) Alteration of Sales and Service Counters – Drawing from the U.S. Access Board
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
11B-809.8 Doors
Primary entry doors, required exit doors, secondary exterior doors and interior doors intended for user passage shall comply with this section and Section 11B-404.2. Doors to small...
-
11B-227 SALES AND SERVICE
[See subsections ...]
-
11B-227 Sales and service.
[See subsections ...]
-
11B-227 Sales and service
[See subsections ...]
-
11B-216.8.1 Geometric symbols
Such spaces include but are not limited to; patient sleeping rooms, transient lodging guest rooms, and residential dwelling units....
-
Kitchen Work Surfaces
The chart accompanying the Guidelines for Requirement 2 is only applicable to the public and common use areas, not to individual dwelling units....
-
Clear Floor Space: ADA Standard Section 606.2
Section 606.2 covers the current ADA Standards for clear floor space at lavatories and sinks.
-
606.2 Clear Floor Space (Exception 3)
Exception 3 to the section permits readily removable cabinetry to be installed under lavatories and sinks in residential dwelling units required to provide mobility features provided that...
-
11B-216.8.1 Geometric symbols
Such spaces include but are not limited to; patient sleeping rooms, transient lodging guest rooms, and residential dwelling units. 2. ...
-
§100.205(c)(3)(iii)
(iii) Reinforcements in bathroom walls to allow later installation of grab bars around the toilet, tub, shower, stall and shower seat, where such facilities are provided; and
-
F202.3 Alterations
Residential dwelling units not required to be accessible in compliance with a standard issued pursuant to the Architectural Barriers Act or Section 504 of the Rehabilitation Act of 1973,...
-
202.3 Alterations
Residential dwelling units not required to be accessible in compliance with a standard issued pursuant to Texas Government Code, Chapter 469, shall not be required to comply with 202.3....
-
Guidelines for Requirement 4
The Guidelines for Requirement 4 present design specifications for providing an accessible route into and through the covered dwelling unit, as required by §100.205(c)(3)(i)....
-
1132A.1 Primary entry doors and required exit doors
., entry or exit doors which open from the covered multifamily dwelling unit into a corridor, hallway or lobby, or directly to the outside)....
