Openings are gaps in the surface of a beach access route. Gaps include spaces between the planks on a boardwalk and drainage holes in temporary or permanent surfaces. Openings that...
Search Results "Towel Bar"
Filters
Commonly Searched Documents
-
Openings in Beach Access Routes
-
6.7 Slope
The slopes of beach access routes shall comply with 6.7.1 and 6.7.2
-
6.10 Openings
Openings in the surface of beach access routes and their related resting intervals may be up to 1/2 inch (13 millimeters) wide. Where possible, elongated openings should be...
-
6.14 Gates and Barriers
Where gates or barriers are constructed to control access to beach access routes, gates and barriers shall comply with 6.14.
-
6.7.1.1
The grade of a Beach Access Route shall be 1:20 (5 percent) or less for any distance.
-
Beach Nourishment
A process by which sediment (usually sand) is added to a beach. An entity is not required to expend more than 20% of the costs of a beach nourishment project to provide a beach...
-
6.7.1 Running Slope (Grade)
The running slope (grade) of a Beach Access Route shall comply with all applicable provisions of this section. Table 6.7.1. Running Slope (Grade) and Resting...
-
1018.7 Slopes
The slopes of beach access routes shall comply with 1018.7.
-
1018.6 Openings
Openings in the surface of beach access routes and resting intervals shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1018.6 Openings....
-
F248.1 General
Beach access routes complying with 1018 shall be provided in accordance with F248.1. Beach access routes shall be permanent or removable. EXCEPTION: Beach access routes shall not...
-
11B-608.3.1 Reserved
11B-608.3.1 Reserved.
-
1. Accessible toilet
Accessible toilet with rear and side grab bars, clear floor space for wheelchair transfer, and an accessible flush valve....
-
A4.16.5 Flush Controls
If administrative authorities require flush controls for flush valves to be located in a position that conflicts with the location of the rear grab bar, then that bar may be split or shifted...
-
A4.16.5 FLUSH CONTROLS
If administrative authorities require flush controls for flush valves to be located in a position that conflicts with the location of the rear grab bar, then that bar may be split or shifted...
-
7(2)(b)
(b) Bathrooms that have reinforced walls for grab bars (see Requirement 6) would meet section 100.205(c)(3)(iv) if: Note: Clear floor space beside tub may overlap with clear floor space...
-
Meeting User Needs
As a result, grab bars on both sides of a toilet that would support a standing transfer were provided rather than alongside and behind the toilet as would be used for a sliding transfer....
-
Bathroom Accommodating Reduced Ambulatory Mobility
Built-in seat in aromatherapy shower Soap dispenser (to prevent a fall from retrieving bar soap from the floor) Vertical and horizontal shower grab bars Hidden fold-down...
-
604.9.6 Dispensers
There shall be a clearance of 1½ inches (38 mm) minimum below the grab bar. Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow....
-
604.9.6 Dispensers
There shall be a clearance of 1 1/2 inches (38 mm) minimum below the grab bar. Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow....
-
604.9.6 Dispensers
There shall be a clearance of 1½ inches (38 mm) minimum below the grab bar. Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow....
-
11B-604.9.6 Dispensers
There shall be a clearance of 1½ inches (38 mm) minimum below the grab bar. Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow....
-
11B-604.9.6 Dispensers
There shall be a clearance of 1½ inches (38 mm) minimum below the grab bar. Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow....