In facilities specializing in treating conditions that affect mobility, 100 percent of the patient sleeping rooms shall provide mobility features complying with 805....
Search Results "Comply With"
-
223.2.2 Facilities Specializing in Treating Conditions That Affect Mobility
-
707 Automatic Teller Machines and Fare Machines
Federal procurement law requires that ITMs purchased by the Federal government comply with standards issued by the Access Board under Section 508 of the Rehabilitation Act of 1973, as amended...
-
703.4.1 Height above Finish Floor or Ground
EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1. ...
-
1009.2.7 Operation
Controls and operating mechanisms shall be unobstructed when the lift is in use and shall comply with 309.4. Advisory 1009.2.7 Operation....
-
Maximum Extent Feasible
The phrase "to the maximum extent feasible," as used in this code, applies to the case where the nature of an existing facility makes it virtually impossible to comply fully with applicable...
-
407.1 General
Elevators shall comply with 407 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1). They shall be passenger elevators as classified by ASME A17.1....
-
224.1.1 Alterations
Where guest rooms are altered or added, the requirements of 224 shall apply only to the guest rooms being altered or added until the number of guest rooms complies with the minimum number...
-
304.2 Floor or Ground Surfaces
Floor or ground surfaces of a turning space shall comply with 302. Changes in level are not permitted. EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
11B-610.3 Shower compartment seats
Seats shall comply with Section 11B-610.3.1 or 11B-610.3.2. [2010 ADAS] 610.3 Shower Compartment Seats. ...
-
11B-706.1 General
Assistive listening systems required in assembly areas, conference and meeting rooms shall comply with Section 11B-706. [2010 ADAS] 706.1 General. ...
-
Smooth Surface
In finalizing the rule, the Board determined that the cost of making existing doors or gates comply with the smooth surface requirement in alterations can be significant....
-
Communication Features in Guest Rooms
It required 1 in 25 rooms to comply up to a guestroom count of 100....
-
§ 382.63 Carrier programs
(3) If the Department determines that any portion of a carrier’s plan must be amended, or provisions added or deleted, in order for the carrier to comply with this part, DOT will direct...
-
Exercise Equipment and Machines
But if the only difference in equipment provided is that they have different manufacturers, but are the same type, only one must comply....
-
R306.3.2 Pedestrian Activated Signals
At roundabouts with multi-lane pedestrian street crossings, a pedestrian activated signal complying with R209 shall be provided for each multi-lane segment of each pedestrian street crossing...
-
Requirement 6. Reinforced walls for grab bars.
Where the toilet is not placed adjacent to a side wall, the bathroom would comply if provision was made for installation of floor mounted, foldaway or similar alternative grab bars....
-
1150A.1 General
Test No. 1 or Test No. 3 is used and it is determined that an accessible route to the common (lobby) entrance is not required, at least 20 percent of the ground floor dwelling units shall comply...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....
-
207 Accessible Means of Egress
Areas of rescue assistance shall comply with 4.3.11....
-
Conclusion
Where the playground surface material fails to comply with safety standards for impact attenuation, children are put at risk of injury. ...
-
Alterations [§202.3]
Only those elements or spaces altered are required to comply, but alterations made to areas containing a primary function (a major activity for which a facility is intended) also require...
-
Section 1194.26 Desktop and Portable Computers (Preamble, Section-by-Section Analysis)
Paragraph (b) provides that systems using touchscreen technology must also provide controls that comply with sections 1194.23 (k) (1) through (4) discussed above....
-
Circulation Paths
Requirement: 4.1.2 (3) All objects that protrude from surfaces or posts into circulation paths shall comply with 4.4. 4.1.3 (2) All objects that overhang or protrude into circulation...
-
11B-703.5.5 Character height
Minimum character height shall comply with Table 11B-703.5.5....