As a facility is altered over time, every effort should be made to disperse accessible patient bedrooms or resident sleeping rooms among patient care areas such as pediatrics, cardiac care...
Search Results "Horizontal Dispersion"
Commonly Searched Documents
-
11B-223.1.1 Alterations
-
1. Sloped Surfaces
The amount of slope or grade is described as the proportion of a vertical rise to a horizontal length....
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
903.4 Back Support
Back support shall be 2½ inches (64 mm) maximum from the rear edge of the seat measured horizontally. Advisory 903.4 Back Support....
-
903.4 Back Support
Back support shall be 2½ inches (64 mm) maximum from the rear edge of the seat measured horizontally. Advisory 903.4 Back Support....
-
R402.3 Post-Mounted Objects
and the objects are 685 mm (2.25 ft) minimum and 2030 mm (6.7 ft) maximum above the finish surface, the objects shall overhang pedestrian circulation paths 100 mm (4 in) maximum measured horizontally...
-
4.1.3(9)*
A horizontal exit, meeting the requirements of local building/life safety regulations, shall satisfy the requirement for an area of rescue assistance....
-
4.1.2(7)
facilities where at-grade egress from each floor is impossible, either of the following is permitted: the provision within each story of approved fire and smoke partitions that create horizontal...
-
1010.1.8 Door arrangement
Exceptions: The minimum distance between horizontal sliding power-operated doors in a series shall be 48 inches (1219 mm)....
- Landscape Forms Inc. Scarborough Bench Collection
-
11B-703.3.2 Position
Braille shall be positioned below the corresponding text in a horizontal format, flush left or centered. If text is multi-lined, Braille shall be placed below the entire text....
-
Side guard protocol
Then from initial setup, the horizontal distance between the wheelchair and platform was incrementally increased and the maximum attainable gap distance was recorded....
-
704.11.1 Parapet construction
Where the roof slopes toward a parapet at a slope greater than two units vertical in 12 units horizontal (16.7-percent slope), the parapet shall extend to the same height as any portion...
-
1132A.4.1 Thresholds
Thresholds with a change in height between ¼ inch (6.35 mm) and 3/4 inch (19.05 mm) shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)...
- HEWI Hinged Support Rail Duo
- Landscape Forms Inc. Parc Vue Bench Collection
- Sargent HP Bored Lock with Push/Pull Trim
- Mockett PCS49B Rectangular Power Grommet
-
20. DESIGN AND CONSTRUCTION STANDARDS
for review and approval a web-based design guide that identifies the ADA Standards requirements for: (1) registration and other service counters; (2) accessible guest room numbers and dispersion...
-
Food and Restaurant Services
Some accessible tables must be provided and must be dispersed throughout the dining area rather than clustered in a single location....
-
Guest Rooms with Communication Features
Commenters suggested that the requirements for scoping and dispersion of guest rooms for persons with mobility impairments and guest rooms with communication features are too complex for...
-
Fixed position maps and kiosks
While it is normally more convenient and practical to mount these maps on vertical surfaces, as is typical for publicly displayed maps, it is better to place tactile maps on a horizontal...