Curb ramps shall be located or protected to prevent their obstruction by parked vehicles....
Search Results "Boarding Ramp"
Filters
Commonly Searched Documents
-
4.7.8 OBSTRUCTIONS
-
382.103 May a carrier leave a passenger unattended in a wheelchair or other device?
382.103 May a carrier leave a passenger unattended in a wheelchair or other device? The carrier and its contractors may not leave a passenger unattended in a wheelchair or other...
-
4.7.3 Width
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
4.7.3 WIDTH
The minimum width of a curb ramp shall be 36 in (915 mm), exclusive of flared sides....
-
Notifying the Access Board When an Entire Trail or Beach Access Route is Exempted [F204.4.1]
In the rare cases where an entire trail or beach access route is exempted, Federal agencies must notify the Access Board about the exemption....
-
Armor-Tile Tactile Systems Cast In Place Detectable Warning Surface System
integral embedment flanges are the complete anchoring system sustains dynamic vehicle loading, AASHTO HS20-44 wheel load test easily cut to conform to angled and radius ramps...
-
ยง 38.159(a)(2) Exception
If portable or station-based lifts, ramps or bridge plates meeting the applicable requirements of this section are provided at stations or other stops required to be accessible under regulations...
-
City of Bend Oregon Curb Ramp Commitment
Requires the Registered User plan or above. Login! -
T204.3 Doorways with Level Boarding and Alighting
Doorways with level boarding and alighting shall comply with T502.3....
-
R308.1.1.1 Dimensions
Boarding and alighting areas shall provide a clear length of 2.4 m (8.0 ft) minimum, measured perpendicular to the curb or street or highway edge, and a clear width of 1.5 m (5.0 ft) minimum...
-
R407.6.4 Change in Direction
Ramps that change direction between runs at landings shall have a clear landing 1.5 m (5.0 ft) minimum by 1.5 m (5.0 ft) minimum....
-
1007.2 Accessible Routes
Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
-
1007.2 Accessible Routes
Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
-
ADA Solutions, Inc. Cast in Place Replaceable Tactile Pavers
The Cast in Place Replaceable Tactile is used for new curb ramps or new construction applications and is the only 100% replaceable Detectable Warning product on the market....
-
Q3: Roadway Resurfacing Alteration Project and Curb Ramp Improvements
Q3: If a roadway resurfacing alteration project does not span the full width of the road, do I have to put in curb ramps?...
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
1008.2.5.1 Ground Level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
1008.2.5.1 Ground Level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
405.2 Slope (Exception 2), 405.6 Rise (Exception)
The running slope of ramp runs must not be steeper than 1:12 and any ramp rise must be 30 inches maximum....
-
Roadway resurfacing, curb ramps at crosswalks
If roadways are being resurfaced or otherwise altered as part of a BRT project, curb ramps must be installed at crosswalks that have been affected. (DOT ADA Standard 106.5.)...
-
1007.2 Accessible Routes
Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
