closer, then the sweep period of the closer shall be adjusted so that from an open position of 70 degrees, the door will take at least 3 seconds to move to a point 3 inches (75 mm) from the latch...
Search Results "Security Latch"
Commonly Searched Documents
-
1133B.2.5.1
-
5.4.10 Transfer Support Fittings Recommendations for M301 and M302
When the transfer supports latch into a locked position, the transfer supports must meet the required load conditions without movement....
-
A. Signs
If signs are provided for the following spaces, are the signs mounted on the wall (not the door) to the latch side of the door and centered 60" above the floor so that they can be easily...
-
§382.129(a)
You must carry out these instructions to the greatest extent feasible, consistent with FAA, PHMSA, TSA, or applicable foreign government requirements concerning security, safety, and hazardous...
-
1013.1 General
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
4.1.4(9)(c)
(c) Institutional occupancies where the occupants are under some degree of restraint or restriction for security reasons including: Facilities Jails Prisons Reformatories...
-
1013.1 General
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
11B-703.7.2.6.2 Women’s toilet and bathing facilities
Exception: Within secure perimeter of detention and correctional facilities, geometric symbols shall not be required to be ¼ inch (6.4 mm) thick....
-
Toilet Compartment Access
So it is still a latch side approach with exactly the same dimensions, including minimum clearances. I'm assuming that we are looking at compliance with the 2010 ADA Standards. ...
- Don-Jo Mfg., Inc. Vertical Rod Protector 83
- Sargent 1331 Series Aluminum Door Closer
-
1.6.18 Terminal.
For the purposes of this AC, a terminal is a distinct area common to and prior to any Transportation Security Administration (TSA) checkpoint, or a distinct sterile area common to and beyond...
-
General: ADA Standard Section 208.3.1
Section 208.3.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for parking space locations.
- Don-Jo Mfg., Inc. Vertical Rod Protector 81
- Salsbury Industries Recessed Mounted Cell Phone Storage Locker 7 Door High Unit Resettable Combination Locks
- Salsbury Industries Recessed Mounted Cell Phone Storage Locker 5 Door High Unit
- Salsbury Industries Recessed Mounted Cell Phone Storage Locker 7 Door High Unit Master Keyed Locks
- Salsbury Industries Recessed Mounted Cell Phone Storage Locker 7 Door High Unit
- Allegion Schlage ND Series Mechanical Locks
-
G. Supplies
Shelters need to have a safe and secure refrigerated location where medications can be stored and accessed when needed....
-
Carpet [4.5.3]
Studies show that the level of roll resistance of carpet, even low-pile carpet that is properly secured, is considerably higher than the roll resistance of firmer surfaces such as concrete...
- Salsbury Industries Cell Phone Storage Lockers
-
11B-703.7.2.6.1 Men’s toilet and bathing facilities
Exception: Within secure perimeter of detention and correctional facilities, geometric symbols shall not be required to be ¼ inch (6.4 mm) thick....
-
4.1.7(3)(b)
Where security is a problem, remote monitoring may be used....