entity shall be permitted to alter or construct a comparable residential dwelling unit to comply with 809.2 through 809.4 provided that the minimum number of residential dwelling units...
Search Results "Covered Dwelling Unit (CBC 11A)"
Filters
Commonly Searched Documents
-
233.3.4 Alterations
-
11B-809.10.7.5 Controls
Controls shall be mounted 44 inches (1118 mm) maximum above the finish floor. The force required to activate controls shall be 5 pounds (22.2 mm) maximum.
-
11B-809.10.8.3 Cabinets
Cabinets shall be removable without the use of specialized knowledge and/or tools. The finished floor shall extend to the wall under the lavatory.
-
11B-809.9.7 Exposed pipes and surfaces
Exposed water supply and drain pipes under sinks and lavatories shall comply with Section 11B-606.5.
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work...
-
Section 35.151(e) Social Service Establishments (Section-by-Section Analysis)
For the first time, residential dwelling units are explicitly covered in the 2004 ADAAG in section 233. ...
-
11B-233.1 General
Many of the CBC accessibility requirements relating to residential facilities are located in Chapter 11A, administered by the California Department of Housing and Community Development (...
-
11B-409.1 General
Private residence elevators that are provided within a residential dwelling unit required to provide mobility features complying with Sections 11B-809.2 through 11B-809.4 shall comply with...
-
11B-409.1 General
Private residence elevators that are provided within a residential dwelling unit required to provide mobility features complying with Sections 11B-809.2 through 11B-809.4 shall comply with...
-
11B-409.1 General
Private residence elevators that are provided within a residential dwelling unit required to provide mobility features complying with Sections 11B-809.2 through 11B-809.4 shall comply with...
-
12.1 Q...How is the individual building test performed for additional stories, to determine if those stories must also be treated as ground floors?
additional ground floors, after the first ground floor has been established, is at the center of the entrance (building entrance for buildings with one or more common entrance and each dwelling...
-
11B-604.3.2 Overlap
Section 11B-608.9), and a threshold, between the shower receptor and the fixture clearance provided outside the shower (CBC Section 11B-608.2.2.1) with a maximum height of ½ inch (CBC Section...
-
1(2)(a)(ii) Site analysis test
(B) To determine the practicality of providing accessibility to planned multifamily dwellings based on the topography of the existing natural terrain, the minimum percentage of ground floor...
-
Multifamily Dwelling
Any building containing more than two dwelling units....
-
MULTIFAMILY DWELLING
Any building containing more than two dwelling units....
-
11.3 Q. The site analysis test calls for a calculation of the percentage of the buildable areas having slopes of less than 10 percent. What is the definition of buildable areas?
A. The buildable area is any area of the lot or site where a building can be located in compliance with applicable codes and zoning regulations.
-
3. Ground and floor surface treatments
Accessible element or space ANSI A117.1 section APPLICATION 3. Ground and floor surface treatments 4.5 Accessible routes,...
-
11B-229.1 General
Glazed openings in residential dwelling units required to comply with Section 11B-809 shall not be required to comply with Section 11B-229. 2. ...
-
Alterations Affecting Primary Function Areas—Exception to Section 202.4 of the 2010 Standards
Under the Exception to Section 202.4, residential dwelling units are exempted from this requirement....
-
1133A.2, Item 1
1. A clear floor space at least 30 inches (762 mm) by 48 inches (1219 mm) that allows a parallel approach by a person in a wheelchair shall be provided at the range or cooktop.
-
1133A.4, Item 1
1. A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation.
-
1132A.9 Smooth surface
1132A.9 Smooth surface. Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side...
-
4.34.5* BATHROOMS
Accessible or adaptable bathrooms shall be on an accessible route and shall comply with the requirements of 4.34.5.
-
4.34.2(2)
(2) Accessible spaces shall have maneuvering space complying with 4.2.2 and 4.2.3 and surfaces complying with 4.5.