There shall be no sharp or abrasive surfaces under the work surface counters....
Search Results "Counter Depth"
Filters
Commonly Searched Documents
-
11B-804.3.3 Exposed surfaces
-
804.3.3 Exposed Surfaces
There shall be no sharp or abrasive surfaces under the work surface counters....
-
11B-804.3.3 Exposed surfaces
There shall be no sharp or abrasive surfaces under the work surface counters....
-
11B-804.3.3 Exposed surfaces
There shall be no sharp or abrasive surfaces under the work surface counters....
-
408.4.1 Car Dimensions and Doors
Elevator cars shall provide a clear width 42 inches (1065 mm) minimum and a clear depth 54 inches (1370 mm) minimum....
-
407.12.3.2.2 Knee and Toe Space
Toe space shall be permitted to provide a clear height of 9 inches (230 mm) minimum above the floor and a clear depth of 6 inches (150 mm) maximum from the vertical reference plane toward...
-
3.3.12 180-Degree Turn around a Barrier
If the barrier is less than 1220 mm (48 in.) wide, the standard calls for a minimum passage width of 1065 mm (42 in.) and a minimum turn-around space depth of 1220 mm (48 in.)....
-
Installation of Test Surfaces
Installation of Test Surfaces In accordance with standard EWF design and construction practice (Figure 2), the full depth surfaces were prepared to the same requirements needed for permanent...
-
Common Problems with New Construction and Alterations
wheelchairs, scooters, crutches, and other with mobility aids often find that both newer and older city and county facilities have parking, routes to and through buildings, high service counters...
-
902.1 General
Dining surfaces include, but are not limited to, bars, tables, lunch counters, and booths....
-
902.1 General
Dining surfaces include, but are not limited to, bars, tables, lunch counters, and booths....
-
11B-809.4 Toilet facilities and bathing facilities
In an effort to promote space efficiency, vanity counter top space in accessible residential dwelling units is often omitted....
-
11B-809.4 Toilet facilities and bathing facilities
In an effort to promote space efficiency, vanity counter top space in accessible residential dwelling units is often omitted....
-
11B-809.4 Toilet facilities and bathing facilities
In an effort to promote space efficiency, vanity counter top space in accessible residential dwelling units is often omitted....
-
F226.1 General
Sales counters and service counters shall not be required to comply with 902. 2....
-
5.2.1.4 Transfer Surface Size Recommendations for Imaging Equipment (M301)
Where the 28 inches minimum depth is technically infeasible, the depth may be no less than 21 inches....
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
11B-904.5 Food service lines
Counters in food service lines shall comply with Section 11B-904.5....
-
11B-904.5 Food service lines
Counters in food service lines shall comply with Section 11B-904.5....
-
11B-904.5 Food service lines
Counters in food service lines shall comply with Section 11B-904.5....
-
2. a. iv. Path-of-Travel (wheelchair) space allowances
Clear ground space width Maximum doorway depth and passage width Turning space: C1. Accessible route turns around an obstruction: C2....
-
Exceptions Considered for Wheelchair Spaces on Raised Platforms
The Access Board is considering adding exceptions in the final standards to the minimum width in M303.2.2 and the minimum depth in M303.2.3 for diagnostic equipment with wheelchair spaces...
-
4.34.6.5* SINK
The sink and surrounding counter shall comply with the following requirements (see Fig. 51):...
-
902.1 General
Dining surfaces include, but are not limited to, bars, tables, lunch counters, and booths....