An enclosed stairway, to be considered part of an accessible means of egress, shall have a clear width of 48 inches (1219 mm) minimum between handrails and shall either incorporate an area...
Search Results "Operable Part (Control)"
2010 ADA Definition
Operable Part (Control): A component of an element used to insert or withdraw objects, or to activate, deactivate, or adjust the element.
-
1003.2.13.2 Enclosed stairways
-
10. Voluntary action
the regulation, to overcome conditions that led to limited participation by handicapped persons, whether or not the limited participation was caused by any discriminatory actions on the part...
-
Pre-boarding as an Option
also permit you to secure the allotted stowage for your wheelchair or assistive device or it may permit easier access to overhead compartments if you are stowing your assistive device or parts...
-
404.2.11 Vision Lights
EXCEPTION: Vision lights with the lowest part more than 66 inches (1675 mm) from the finish floor or ground shall not be required to comply with 404.2.11....
-
Platform Size and Surface
Platform Size and Surface To be part of an accessible route, lift platforms must provide the amount of clear space required for wheelchairs in ADAAG 4.2.4....
-
4.1.6(1)(j) EXCEPTION
or a facility, that it has little likelihood of being accomplished because existing structural conditions would require removing or altering a load-bearing member which is an essential part...
-
1.1.7 Measurement of parking areas
Only accessible access aisles and passenger loading zones that are part of a larger parking area need to be measured....
-
§ 38.159(b)(6) Platform surface
(See Figure 1 to this part.) ...
-
§ 38.23(d)(2) Location and size
Not more than 6 inches of the required clear floor space may be accommodated for footrests under another seat provided there is a minimum of 9 inches from the floor to the lowest part of...
-
Gamco Surface Mounted Hand Dryer - DR-5128
Motor shall be thermally-protected universal brush type motor operating at 13000 rpm and delivering 70 cfm air flow at a velocity of 140 MPH (12320 lfm), and cETLus approved....
-
Panda TS.13 Aluminum/Wood Clad Thermally Broken Lift & Slide System
For best operation, floor must be smooth and level....
-
Panda S.11 Aluminum/Wood Clad Lift & Slide System
For best operation, floor must be smooth and level....
-
Smooth Surface
This provision requires that parts creating joints in the smooth surface are to be within 1/16 inch of the same plane as the other....
-
ACCESS
Check this manual (and Appendix V containing the full text of Part 382) and your carrier’s policies (concerning the law as well as good customer service) to identify the issue at hand....
-
Miscellaneous Provisions
These are obsolete provisions concerning over-the-road buses that are no longer needed, given the passage of time since the promulgation of subpart H of part 37....
-
12. I am doing a small tenant improvement project, but I cannot afford the required accessibility improvements. Can I claim a hardship exemption?
These improvements, called "path-of-travel" improvements, are improvements that are not part of the area of alteration, but require improved access to the altered area from accessible parking...
-
Section 1630.6 Contractual or Other Arrangements
Part 1630 notes that this provision applies to parties on either side of the contractual or other relationship....
-
Check-Out Aisles and Sales and Service Counters
It is a clarification of the ongoing requirement that part of the sales and service counter be accessible....
-
X. Alterations
Alterations to windows, hardware, controls, electrical outlets, and signage in primary function areas do not trigger the path of travel requirement....
-
Other international standards
TR 34 Concrete Industrial Ground Floors—Specification and Control of Surface Regularity of Free Movement Areas, UK Concrete Society (provides for three classes of industrial surfaces...
-
Training requirement. (Section-by-Section Analysis)
address the obligations of the service animal user and the circumstances under which a service animal may be excluded, such as the requirements that an animal be housebroken and under the control...
-
A4.4.1 GENERAL
The touch technique is used primarily in uncontrolled areas, while the diagonal technique is used primarily in certain limited, controlled, and familiar environments....
-
A4.4.1 General
The touch technique is used primarily in uncontrolled areas, while the diagonal technique is used primarily in certain limited, controlled, and familiar environments....
-
Training requirement. (Section-by-Section Analysis)
address the obligations of the service animal user and the circumstances under which a service animal may be excluded, such as the requirements that an animal be housebroken and under the control...
