(1) Wall- and post-mounted cantilevered units shall have a clear knee space between the bottom of the apron and the floor or ground at least 27 in (685 mm) high, 30 in (760 mm) wide, and...
Search Results "Sand Bottom Pool"
Commonly Searched Documents
-
4.15.5(1)
-
4.34.6.10* KITCHEN STORAGE
(2) Door pulls or handles for wall cabinets shall be mounted as close to the bottom of cabinet doors as possible....
-
11B-406.5.10 Diagonal curb ramps
The bottom of diagonal curb ramps shall have a clear space 48 inches (1220 mm) minimum outside active traffic lanes of the roadway....
-
Safe Harbor
machines and equipment Fishing piers and platforms Golf facilities Miniature golf facilities Play areas Saunas and steam rooms Swimming pools...
-
Reduced scoping for public accommodations, small facilities, and qualified small businesses. (Section-by-Section Analysis)
initial regulatory assessment, the Department has identified ten elements for which the Department believes reduced scoping might be appropriate for barrier removal: play areas, swimming pools...
-
Revised and New Standards for Buildings and Facilities
New standards that apply to places of lodging also cover requirements for accessible swimming pools and spas, exercise facilities, saunas and steam rooms, golf and miniature golf courses...
-
ASME A18.1 Safety Standard [§410.1]
Lifts without platforms, including stairway chairlifts, are not permitted by the ADA Standards except at swimming pools and spas because they require transfer from wheeled mobility aids....
-
404 Doors, Doorways, and Gates
clearance requirements (404.2.4) modify requirements for doors and gates in series (404.2.6) clarify the height of door and gate hardware and add an exception for gates at pools...
-
4.35.4 Bench
Where installed in conjunction with showers, swimming pools, or other wet locations, water shall not accumulate upon the surface of the bench and the bench shall have a slip-resistant surface...
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE. ...
-
405.7 Landings
Ramps shall have landings at the top and the bottom of each ramp run. Landings shall comply with 405.7. Advisory 405.7 Landings....
-
502.6 Identification
Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. Advisory 502.6 Identification....
-
Is there a minimum distance between changes in level?
Ramps and curb ramps, which must be used to span vertical changes greater than ½”, must have level landings and clearances at the tops and bottoms of each run to provide adequate separation...
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE....
-
KICK PLATE
An abrasion-resistant plate affixed to the bottom portion of a door to prevent a trap condition and protect its surface. Advisory Definition of KICK PLATE....
- Make A Hero
- Sargent 8700 Surface Vertical Rod Exit Device
-
What other considerations are significant for persons with disabilities?
Materials such as gravel, wood chips, or sand, often used for outdoor walkways, are neither firm nor stable, nor can they generally be considered slip-resistant....
-
Costs and Personnel Time for EWF Installation
The estimates do not include the significant amount of personnel time required to remove the sand from the playground....
-
RESULTS OF OBJECTIVE SURFACE MEASUREMENT
Wheelchair work per meter values were not obtained for sand because it was not possible to propel the wheelchair through this surface....
-
Grab Bars
Grab bars must be perpendicular to the pool wall and extend the full width of the wall so a person can use them for support into the water....
-
1009.4.5 Grab Bars
Grab bars shall be perpendicular to the pool wall and shall extend the full depth of the transfer wall....
-
B. Interior Ramps
(3) Third Floor North Corridor (Route to Fitness Center, Pool, and Spa) - This corridor will be modified so that its running slope does not exceed 1:20 (5%) or 1:12....
- Landscape Forms Inc. Palisade Bench Collection