While a majority of the Committee members supported a recommendation allowing both noncircular and circular cross sections, some members noted ergonomic considerations support the better...
Search Results "Recommend"
Filters
Commonly Searched Documents
-
M305.2.4 Cross Section (Section-by-Section Analysis)
-
M301.2.1, M302.2.1 Transfer Height
• Sub-Committee Recommendation: 17 inches with exceptions....
-
3.3.1 Research Data
As mentioned in descriptions of the rationale for various standard recommendations, the Committee found the IDeA data to be very helpful. However, as noted by Dr....
-
Overview
This document is the initial response to the GAO recommendation that “the Secretary of Education facilitate information sharing among states and schools on ways to provide opportunities...
-
Transfer Sides (M301.2.3 and M302.2.3)
This is consistent with ANSI/AAMI HE 75 which recommends that “side rails, arm rests, leg supports . . . should be positioned, or able to be moved out of the way, so as not to interfere...
-
d. Unobstructed Transfer
This data helped inform the recommendation for the exception since the 3-inch criteria is less than that used in the research and should assure effective transfers for most.”...
-
5. Exception from the Requirements of M302 for Weight Scales with Integral Seats
However, the MDE Advisory Committee did not make specific recommendations for requiring a folding seat on diagnostic equipment used in the standing position, nor did it make any specific...
-
Rockwood Manufacturing Company 215 Tapered Door Pull 16"
Options: • Use Y prefix (Y215) when ordering pulls with base plates, Y plate diameter is 1-1⁄16"; recommended for use on glass or wood doors....
-
Rockwood Manufacturing Company 215L Tapered Door Pull 28"
Options: • Use Y prefix (Y215) when ordering pulls with base plates, Y plate diameter is 1-1⁄16"; recommended for use on glass or wood doors....
-
Aluminum Heavy Duty Wheels n' Heels® InVent Grating
A slip resistant surface is recommended to meet ADA guidelines. Also available in Stainless Steel upon request....
-
American Standard Jetbrook Urinal
spud Outlet connection threaded 2" inside (NPTF) Wall hanger Fixture only Meets ANSI flush requirements at 1.0 GPF Nominal Dimensions: 527 x 356 x 400mm (20-3/4" x 14" x 16") Recommended...
-
Mohawk Group Chilled Check Carpet Tiles
Install tiles from any dye lot Random/multidirectional install method recommended for optimal results No need to purchase large quantities of attic stock Easy replacement of tiles...
-
INTRODUCTION
Development and Defense, and the United States Postal Service) that are authorized to issue standards under the Architectural Barriers Act, and between those standards and the access standards recommended...
-
302 Floor or Ground Surfaces
The final rule does not include any technical specifications or testing methods for slip resistance as recommended by comments....
-
Tactile Surface
Some commenters recommended that these provisions were unnecessary in view of the general provision for equivalent facilitation in section 103 permitting departures from this or any other...
-
R304.5.1.2 Shared Use Paths
The AASHTO Guide recommends that where curb ramps are provided on shared use paths, the curb ramps should extend the full width of the path, not including any flared sides....
-
QUESTION: HOW WILL THE DEPARTMENT IMPLEMENT THE CONFLICT OF LAW WAIVER REQUEST PROVISIONS OF PART 39?
., a statute or a rule) rather than guidance or a recommendation. It must explicitly prohibit something that Part 39 requires or explicitly require something that Part 39 prohibits....
-
404.2.7 Door and Gate Hardware
Hardware that requires simultaneous hand and finger movements require greater dexterity and coordination and is not recommended....
-
404.2.7 Door and Gate Hardware
Hardware that requires simultaneous hand and finger movements require greater dexterity and coordination, and is not recommended....
-
Bathroom Do’s and Dont’s
This is recommended, even if the floor is sloped near the shower drain. Be sure the grate of the floor drain is accessible so wheelchair wheels do not get caught in the slats. ...
-
404.2.7 Door and Gate Hardware
Hardware that requires simultaneous hand and finger movements require greater dexterity and coordination and is not recommended....
-
Training requirement. (Section-by-Section Analysis)
Certain commenters recommended the adoption of formal training requirements for service animals....
-
x. Scoping and Triggering Events for Medical Equipment and Furniture
Scoping and Triggering Events for Medical Equipment and Furniture If the Department proposes a rule recommending regulations requiring accessible medical equipment and furniture, it should...
