Office buildings and passenger vehicle service stations of three stories or more and 3,000 or more square feet (279 m2) per floor. 2. ...
Search Results "Floor Surface"
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
For example, floors above or below the accessible ground floor must meet the requirements of this section except for elevator service....
-
Accessible Means for Gathering Feedback
., the desk must be on an accessible route and have a writing surface at the required height or a clipboard available for people who use wheelchairs)....
-
Issue 10: Braille (right side up?)
Remedy: Braille is made up of small dots in a grid which are raised on the surface to be read by fingertip....
-
Back Support
In addition, clarification has been added that the dimensions for back support are measured from the surface of the seat. Comment....
-
1131B.2, Item 1
Vehicle standing spaces and access aisles shall be level with surface slopes not exceeding one unit vertical in 50 units horizontal (2-percent slope) in all directions....
-
Observations:
The wheelchair scale we used had a leveled surface of length 30 in. long with a bevel of 5 in. each at both ends (i.e., total length of 40 in.)....
-
Mobility
Typical problems include maneuvering through narrow spaces, going up or down steep paths, moving over rough or uneven surfaces, using toilet and bathing facilities, reaching and seeing items...
-
Future Work
The next phase of study will research alternative hand placement options for both initial hand placement and repositioning upon landing on the target surface. ...
-
D) Curb Ramps at Intersections
When walkways cross a curb at intersections, a ramp or sloped surface is needed. The title II regulations set requirements for curb ramps at intersections....
-
Stanley QED 100 Series Grade 1 Extra Heavy Duty Exit Devices
In addition, all exit devices are offered in rim, rim fire, surface vertical rod, surface vertical rod fire and surface vertical-less bottom rod configurations....
-
Issue 1: APS volume
Note that nearby building facades or other hard surfaces that reflect the APS signal may actually cause the APS to increase in volume in reaction to its own sound, if the sound or ambient...
-
The Limits of Utilizing a Cost-Benefit Analysis
To our knowledge there are no studies that provide a fully comprehensive analysis of the effects of the height of a transfer surface on people with various disabilities....
-
6.2 Presentations that Informed the Minimum Height Deliberations
Minimum Height Deliberations As described in Section 3.3, Advisory Committee members considered several different types of evidence in their deliberations about the minimum transfer surface...
-
Panda TS.75 Aluminum Wood Clad Thermally Broken Folding Door System
This track flush with the finished floor for a “barefoot” friendly area and a seamless transition from the interior to the exterior....
-
Panda S.74 Aluminum Wood Clad Folding Door System
This track flush with the finished floor for a “barefoot” friendly area and a seamless transition from the interior to the exterior....
-
11B-205.1 General
Floor electrical receptacles shall not be required to comply with Section 11B-309. 5. HVAC diffusers shall not be required to comply with Section 11B-309. 6. ...
-
Accessible Fishing Piers and Platforms
If railings, guards, or handrails are provided, accessible edge protection and clear floor or ground space at accessible railings are required....
-
Kitchen Appliances
Section 309 includes specifications for clear floor space (309.2), height (309.3), and operating characteristics (309.4)....
-
11B-233.3.4.1 Alterations to vacated buildings
Exception: Where any portion of a building’s exterior is preserved, but the interior of the building is removed, including all structural portions of floors and ceilings and a new building...
-
1136A.2 Switch and control heights
located no more than 48 inches (1219 mm) measured from the top of the outlet box nor less than 15 inches (381 mm) measured from the bottom of the outlet box to the level of the finished floor...
-
1117B.1, Item 5
The bubbler outlet orifice shall be located within 6 inches (152mm) of the front edge of the drinking fountain and within 36 inches (914 mm) of the floor....
-
1117B.1, Item 4
The bubbler outlet orifice shall be located within 6 inches (152mm) of the front edge of the drinking fountain and within 36 inches (914 mm) of the floor....
-
Wheelbase Definition
Wheelbase Definition For the purpose of this analysis, wheelbase is defined as the distance from the center of the primary drive wheel to the center of the caster measured parallel to the floor...
