An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
Search Results "Raised Key"
Filters
Commonly Searched Documents
-
11B-203.11 Water slides
-
11B-1009.2.2 Seat location
In the raised position, the centerline of the seat shall be located over the deck and 16 inches (406 mm) minimum from the edge of the pool....
-
11B-707.3 Operable parts
Unless a clear or correct key is provided, each operable part shall be able to be differentiated by sound or touch, without activation....
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars raised...
-
C. Keyword Definitions
Following is a list of key words whose definitions will help you fully understand this manual....
-
DOT Response
In the Department's view, the ADA does not provide a statutory basis for requiring the expansion of the list of key stations, renovation of which for accessibility was to have been completed...
-
§ 1194.26(a)
(a) All mechanically operated controls and keys shall comply with §1194.23 (k) (1) through(4)....
-
§382.91(b)(1)
(1) This requirement includes assistance in accessing key functional areas of the terminal, such as ticket counters and baggage claim....
-
§ 37.47(d)(2)
(2) The plan shall establish milestones for the achievement of required accessibility of key stations, consistent with the requirements of this section....
-
§ 37.51(d)(2)
(2) The plan shall establish milestones for the achievement of required accessibility of key stations, consistent with the requirements of this section....
-
A. Examples of Policies and Practices That Facilitate ADA Compliance
Department of Justice settlement agreements provide examples of policies and procedures that assist in achieving ADA compliance in key areas....
-
E102.8.1 TIA 825-A
A Frequency Shift Keyed Modem for Use on the Public Switched Telephone Network, (2003), IBR proposed for Section 410.6.3.1....
-
C102.8.1 TIA 825-A
A Frequency Shift Keyed Modem for Use on the Public Switched Telephone Network, (2003), IBR proposed for Section 410.6.3.1....
-
§ 37.153(c)(2)(i)
(i) For purposes of this section, key routes are defined as routes along which there is service at least hourly throughout the day....
-
11B-411.2.1.5.1 Size
Buttons shall have square shoulders, be 3/4 inch (19.1 mm) minimum in the smallest dimension and shall be raised 1/8 inch (3.2 mm) plus or minus 1/32 inch (0.8 mm) above the surrounding...
-
§ 1194.23(k)(4)
(4) The status of all locking or toggle controls or keys shall be visually discernible, and discernible either through touch or sound....
-
11B-411.2.3.2 Car designation signs
Signs shall be provided in both raised characters and Braille. Raised characters shall be 2 inches (51 mm) high. Raised characters shall be white on a black background....
-
11B-411.2.3.2 Car designation signs
Signs shall be provided in both raised characters and Braille. Raised characters shall be 2 inches (51 mm) high. Raised characters shall be white on a black background....
-
11B-407.4.7.1.2 Location
Raised characters or symbols and Braille designations shall be placed immediately to the left of the control button to which the designations apply. Exception: Reserved....
-
f-iv
Does the lift allow a person using a mobility device unassisted entry, operation (is key available, if required), and exit? Yes No...
-
§ 37.53(c)
(c) In making accessible the key stations identified under the agreements cited in this section, the entities named in the agreements are subject to the requirements of §37.9 of this part...
-
11B-411.2.3.1 Floor designation signs
Signs shall be provided in both raised characters and Braille. Raised characters shall be 2 inches (51 mm) high....
-
11B-411.2.3.1 Floor designation signs
Signs shall be provided in both raised characters and Braille. Raised characters shall be 2 inches (51 mm) high....
-
11B-411.2.3.1 Floor designation signs
Signs shall be provided in both raised characters and Braille. Raised characters shall be 2 inches (51 mm) high....