[See subsections ...]
Search Results "Horizontal Standing Support"
Commonly Searched Documents
-
Chapter 6: Support Documentation aAnd [sic] Services
- Handicap Awareness and Support League (HASL)
- Association of People Supporting Employment First (APSE)
-
RAMP
A walking surface that has a running slope steeper than one unit vertical in 20 units horizontal (5-percent slope)....
-
Accessible Means of Egress
A continuous and unobstructed way of egress travel from any point in a building or facility that provides an accessible route to an area of refuge, a horizontal exit, or a public way....
-
704.11.1 Parapet construction
Parapets shall have the same fire-resistance rating as that required for the supporting wall, and on any side adjacent to a roof surface, shall have noncombustible faces for the uppermost...
-
Play Component
Play components are manufactured or natural; and are stand-alone or part of a composite play structure....
-
TRANSIT BOARDING PLATFORM
[DSA-AC] A horizontal, generally level surface, whether raised above, recessed below or level with a transit rail, from which persons embark/disembark a fixed rail vehicle....
-
11B-703.3 Braille
Some contractions stand for a whole word and other contractions stand for a group of letters within a word....
- Spectrum Aquatics Gallatin Water Powered Assisted Access Lift
-
PLAY COMPONENT
Play components are manufactured or natural, and are stand-alone or part of a composite play structure....
-
4.1.3 Adjustable Height Chairs with and without Footplates
Figure 4.1 shows the chair when configured in an upright seated position; these same patient support surfaces (made up of the back, seat, and leg rests) are repositioned horizontally to...
-
C. Chapter 3: Technical Requirements (Section-by-Section Analysis)
; diagnostic equipment used by patients in a seated position (M302); diagnostic equipment used by patients seated in a wheelchair (M303); and diagnostic equipment used by patients in a standing...
-
Benches
If the bench is not located next to a wall, the bench must have back support that is 42 inches minimum in length and extends from a point 2 inches maximum above the seat to a point 18 inches...
-
d) Paving Guidelines
The mere possibility that the City will delay construction of a curb ramp and that Kirola may be injured as a result is simply "'too speculative to support standing.'" Ervine v....
- Endorphin 325 Functional Wall Pulley
- Work Support of Virginia Commonwealth University
-
307.2 Protrusion Limits
Objects with leading edges more than 27 inches (685 mm) and not more than 80 inches (2030 mm) above the finish floor or ground shall protrude 4 inches (100 mm) maximum horizontally into...
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...
-
11B-505.10.1 Top and bottom extension at ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
Accessible Route
included to ensure an equal level of convenience between accessible seating and inaccessible seating in terms of travel between the entry gate and seats or between the seats and concession stands...
-
6. Classroom Acoustics
The Board is undertaking rulemaking to address acoustics in classrooms by referencing a voluntary consensus standard developed by the Acoustical Society of America (ASA) with support from...