Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical....
Search Results "Vertical Reference Plane"
-
1132A.4.1, Item 1
-
1132A.4.1, Item 1
Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical....
-
Priority 1: Approach & Entrance
Word Fillable Form (1.5MB) Word Non-Fillable Form (1.3MB) PDF Non-Fillable Form (0.8MB)
-
R105.2 Terms Defined in Referenced Standards
Terms used in specific sections of the MUTCD that are incorporated by reference in this document shall have the meaning specified in section 1A.13 of the MUTCD (incorporated by reference...
-
105.1 General
The standards listed in 105.2 are incorporated by reference in this document and are part of the requirements to the prescribed extent of each such reference....
-
Honeywell SpectrAlert Advance Selectable Output Devices
Electrically compatible with legacy SpectrAlert Advance devices Compatible with MDL3 sync module Listed for ceiling or wall mounting Related Resources Audible/Visible Appliance Reference...
-
Mounting Height
What is most important is that strobes, whether projecting from walls or suspended from ceilings, be at least 6 inches below the ceiling plane to minimize smoke obscuration....
-
11B-810.2.3 Connection
shall provide a detectable transition between the boarding/alighting area and the roadway; the detectable transition shall consist of a curb with the face sloped at 35 degrees maximum from vertical...
-
11B-810.2.3 Connection
shall provide a detectable transition between the boarding/alighting area and the roadway; the detectable transition shall consist of a curb with the face sloped at 35 degrees maximum from vertical...
-
1.1.1 Title
These regulations shall be known as the California Building Code, may be cited as such and will be referred to herein as "this code."...
-
T402.9 Transitions
Vertical surface discontinuities at transitions from boarding and alighting areas to ramps and bridgeplates shall comply with T302.4....
-
§35.171(a)(2)(i)
(i) If an agency other than the Department of Justice determines that it does not have section 504 jurisdiction and is not the designated agency, it shall promptly refer the complaint, and...
-
§ 36.302(b)(2) Illustration
A health care provider may refer an individual with a disability to another provider, if that individual is seeking, or requires, treatment or services outside of the referring provider's...
-
Sec.36.302(b)(2)
A health care provider may refer an individual with a disability to another provider, if that individual is seeking, or requires, treatment or services outside of the referring provider's...
-
Water Coolers
The term "water coolers" typically refers to units that are either identical to drinking fountains or to furnishings that are not fixed or plumbed....
-
Additional clarification requested
Please add 2010 ADA cite reference...
-
Where do I measure for a handrail extension?
For the short answer, jump to our Conclusion and open the attached PDF sketches for reference. For the rationale behind our review, please read the following Detailed Analysis. ...
-
Dispersion Requirements
Like the proposed rule, specifications are provided for horizontal (side to side) and vertical (front to back) dispersion....
-
1003.2.12.1 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
1003.2.12.1 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
11B-221.2.1.5 Stadium-style movie theaters
satisfy at least one of the following criteria: Located within the rear 60 percent of the seats provided in the theater; or Located within the area of the theater in which the vertical...
-
ADA Chapter 2: Scoping Requirements
Throughout this chapter and the rest of the document, the term "accessible" has been replaced with more precise references to applicable criteria in the guidelines....
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
