[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for...
Search Results "Ramp Handrail"
Filters
Commonly Searched Documents
-
SECTION 1012 RAMPS
-
Boost Your Business - Chapter 5 - Curb Ramps
Boost Your Business - Chapter 5 - Curb Ramps...
-
R409.7.1 Circular Cross Section
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 32 mm (1.25 in) minimum and 51 mm (2 in) maximum....
-
B6. Curb Ramp Slope
If a curb ramp is provided, is the slope of the ramp surface (not counting the side flares) no more than 1:12? [ADA Stds 4.7.2] Yes _____ No _____...
-
Q6: Curb Ramp Installation Work on Separate Contract
Q6: Is the curb ramp installation work required to be a part of the Plans, Specifications and Estimate package for an alteration project or can the curb ramp work be accomplished under a...
-
R305.2.2 Parallel Curb Ramps
R305.2.2 Parallel Curb Ramps. On parallel curb ramps, detectable warning surfaces shall be placed on the turning space at the flush transition between the street and sidewalk....
-
4.26.4 Eliminating Hazards
A handrail or grab bar and any wall or other surface adjacent to it shall be free of any sharp or abrasive elements. Edges shall have a minimum radius of 1/8 in (3.2 mm)....
-
4.26.4 ELIMINATING HAZARDS
A handrail or grab bar and any wall or other surface adjacent to it shall be free of any sharp or abrasive elements. Edges shall have a minimum radius of 1/8 in (3.2 mm)....
-
1007.2 Accessible Routes
Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
-
1007.2 Accessible Routes
Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
-
SECTION 1022 INTERIOR EXIT STAIRWAYS AND RAMPS
SECTION 1022 INTERIOR EXIT STAIRWAYS AND RAMPS...
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps are perpendicular or parallel curb ramps that are oriented diagonally at an intersection....
-
Landings
Landings Landings are the level surfaces at the top and bottom of each ramp run....
-
d-v
If a ramp is longer than 30 feet, is a level landing at least 60 inches long provided every 30 feet? [ADA Standards § 4.8.4] Yes No...
-
Problem One (Ramps)
Problem One: There is a six inch high step on the accessible route that has a ramp that is only three feet long, making the ramp too steep and, therefore, inaccessible....
-
1007.2 Accessible Routes
Ramp landing slopes specified by 405.7.1 shall be permitted to be 1:20 maximum. 5....
-
11B-1007.2 Accessible routes
Ramp landing slopes specified by Section 11B-405.7.1 shall be permitted to be 1:20 maximum....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
Sides of Curb Ramps
Commenters advised that landings should be specified at the top of curb ramps. Response....
-
R207 Curb Ramps and Blended Transitions (Section-by-Section Analysis)
R207 Curb Ramps and Blended Transitions (Section-by-Section Analysis) Curb ramps, blended transitions, or a combination of curb ramps and blended transitions must connect the pedestrian...
-
When Ramps Are Required
When Ramps Are Required Ramps are required on composite structures with 20 or more elevated play components and must connect to at least 25 percent of the elevated play components. ...
-
§ 38.97(c)
(c) At entrances equipped with steps, handrails or stanchions shall be provided in the entrance to the car in a configuration which allows passengers to grasp such assists from outside the...
-
R305.2.1 Perpendicular Curb Ramps
R305.2.1 Perpendicular Curb Ramps. On perpendicular curb ramps, detectable warning surfaces shall be placed as follows: 1....
-
Figure 406.4 Landings at the Top of Curb Ramps – Drawing from the U.S. Access Board
