Latch bolts must be retracted and other devices that keep doors or gates closed must be disengaged prior to measuring the opening force....
Search Results "Measuring Instrument"
-
Opening Force [§404.2.9]
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
-
E102.8.2 TIA 1083
Telephone Terminal Equipment Handset Magnetic Measurement Procedures and Performance Requirements, (March 2007), IBR proposed for Section 410.4.2....
-
II. Research Methodology
four (4) rounds; however results from the first round made it evident to the research team and the funding agencies that modifications were necessary not only pertaining to the initial instrument...
-
II-1.2000 Public entity
A public entity covered by title II is defined as -- 1) Any State or local government; 2) Any department, agency, special purpose district, or other instrumentality of a State or local...
-
Impact Annenuation [sic]
The handheld instrumentation package is being held by Ted Illjes on the ladder and is connected to the impactor via the coiled wire....
-
1014.2.1.2 Floor Height
The camp shelter floor at the entrance shall be 19 inches (485 mm) high maximum measured from the clear ground space....
-
§ 36.304(c) Priorities
A public accommodation is urged to take measures to comply with the barrier removal requirements of this section in accordance with the following order of priorities....
-
Sec.36.304(c) Priorities
A public accommodation is urged to take measures to comply with the barrier removal requirements of this section in accordance with the following order of priorities....
-
Technical Requirements
Are the specific numbers, conditions, and measurements that are required to be achieved (percent that must comply, dimensions, reach ranges, grades, trail width, etc.)....
-
1013.4 Height
This section requires tent platforms to be 19 inches high maximum measured from the clear ground space to the tent platform surface....
-
Technical Requirements
The specific numbers, conditions, and measurements that are required to be achieved (percent that must comply, dimensions, reach ranges, grades, trail width, etc.). ...
-
1014.2.1.2 Floor Height
The camp shelter floor at the entrance shall be 19 inches (485 mm) high maximum measured from the clear ground space....
-
1.6.17 Sterile Area.
A portion of an airport, specified in the airport security program, in which certain security measures specified in 49 CFR part 1542, Airport Security, are carried out....
-
604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured to the top of the seat....
-
604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured to the top of the seat....
-
604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured to the top of the seat....
-
2. Referenced Documents
2.1 ASTM standards E867 Standard Terminology Relating to Vehicle-Pavement Systems E1364 Standard Test Method for Measuring Road Roughness by Static Level Method E1926 Standard...
-
Acknowledgments
Acknowledgments The development of objective surface measurement devices and objective surface testing was conducted with funding from the National Center for Medical Rehabilitation Research...
-
604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured to the top of the seat....
-
11B-609.4 Position of grab bars
Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
I. Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps
While the dynamic coefficient of friction during walking varies in a complex and non-uniform way, the static coefficient of friction, which can be measured in several ways, provides a close...
-
M301.2.3 Size
The size of transfer surfaces shall be measured from center points of their opposing sides....
-
1013.4 Height
Tent platforms shall be 19 inches (485 mm) high maximum measured from the clear ground space to the tent platform surface....