The total number of such 30-inch by 48-inch (760 mm by 1220 mm) areas per story shall be not less than one for every 200 persons of calculated occupant load served by the area of rescue...
Search Results "Loading Condition"
Filters
Commonly Searched Documents
-
4.3.11.2 Size
-
11B-1009.2.4 Seat
of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the raised (load...
-
11B-1009.2.4 Seat
of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the raised (load...
-
Exception [1013.1, Exception]
When a condition for exception does not permit full compliance with a specific provision in the technical requirements for tent pads and tent platforms, the tent pads and tent platforms...
-
Guldmann GH3 Lifting Module
Condition for Use - The use of the GH3 is subject to the following: The GH3 should only be used by trained personnel....
-
Are transportation operators required to retrofit their vehicles to accommodate larger and heavier wheelchairs?
No. 49 CFR Part 38 continues to require that lifts have a minimum design load of 600 pounds and the lift platform accommodates a wheelchair measuring 30 inches by 48 inches....
-
Are transportation operators required to retrofit their vehicles to accommodate larger and heavier wheelchairs?
No. 49 CFR Part 38 continues to require that lifts have a minimum design load of 600 pounds and the lift platform accommodates a wheelchair measuring 30 inches by 48 inches....
-
1002.5.1 Clear Floor or Ground Space
A clear floor or ground space complying with 305 shall be provided in the load and unload area adjacent to the amusement ride seats designed for transfer....
-
11B-211.2 Minimum number
Plumbing Code (CPC), Table 4-1 provides minimum plumbing fixture requirements for new buildings, and changes of occupancy or use in an existing building resulting in increased occupant load...
-
406.2.2 Clear height
this section, greater vertical clearance is required at van-accessible parking spaces, standard accessible parking spaces, the vehicular routes to these spaces, and passenger drop-off and loading...
-
11B-403.5.1 Clear width
The clear width for walking surfaces in corridors serving an occupant load of 10 or more shall be 44 inches (1118 mm) minimum. 3. ...
-
What obligations does an employer have to provide health insurance to employees with HIV or AIDS?
Thus, for example, blanket pre-existing condition clauses that exclude from the coverage of a health insurance plan the treatment of all physical conditions that predate an individual’s...
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
1002.6.2 Transfer Height
The height of transfer device seats shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-233.3.1.2.6 Public housing facility site impracticality
this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator, located on sites with difficult terrain conditions...
-
11B-1009.2.4 Seat
of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the raised (load...
-
F206.2.8.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
When amusement rides are in the load and unload position, wheelchair spaces complying with 1002.4, amusement ride seats designed for transfer complying with 1002.5, and transfer devices...
-
206.2.9.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
When amusement rides are in the load and unload position, wheelchair spaces complying with 1002.4, amusement ride seats designed for transfer complying with 1002.5, and transfer devices...
-
STRUCTURAL IMPRACTICABILITY
Changes having little likelihood of being accomplished without removing or altering a load-bearing structural member and/or incurring an increased cost of 50 percent or more of the value...
-
2) Valet parking
2) Valet parking ADAAG: Facilities with valet parking must have an accessible passenger loading zone on an accessible route to the exterior of the facility (§4.1.2(5)(e))....
-
16(f)
(f) At the same time that it submits its survey to the ADA Consultant, each hotel owner shall be required to either (i) certify that its hotel complies with all of the conditions set forth...
-
§382.99(a)
carrier, you must negotiate in good faith with the airport operator of each U.S. airport described in §382.95(b) to ensure the provision of lifts for boarding and deplaning where level-entry loading...
-
4.1.3(8)(a)(i)
Public entrances are any entrances that are not loading or service entrances....
