Certain alterations or additions to a facility may trigger the requirement for an accessible route between floors, including: where stairs or escalators are added in an alteration...
Search Results "Floor Designation"
Commonly Searched Documents
-
Existing Elevators (Alterations)
-
11B-233.3.4.1 Alterations to vacated buildings
Exception: Where any portion of a building’s exterior is preserved, but the interior of the building is removed, including all structural portions of floors and ceilings and a new building...
-
1136A.2 Switch and control heights
located no more than 48 inches (1219 mm) measured from the top of the outlet box nor less than 15 inches (381 mm) measured from the bottom of the outlet box to the level of the finished floor...
-
11B-205.1 General
Floor electrical receptacles shall not be required to comply with Section 11B-309. 5. HVAC diffusers shall not be required to comply with Section 11B-309. 6....
-
1136A.2 Switch and control heights
located no more than 48 inches (1219 mm) measured from the top of the outlet box nor less than 15 inches (381 mm) measured from the bottom of the outlet box to the level of the finished floor...
-
Lines of Sight for Wheelchair Spaces
Comments from designers indicated that the admission price criterion is problematic since prices are not typically known in the design and construction phase....
-
SIGNALIZATION OF ROUNDABOUTS
Figure 4 shows an example of a flared entry and exit design. The flared design is intended to increase roundabout vehicle capacity....
- Tri-County Center for Independent Living (TCIL) - Rolla, MO
-
D. Department of Justice Activities Related to Health Care Providers and Medical Equipment
The guidance document includes information on accessible examination rooms and the clear floor space needed adjacent to medical equipment for individuals who use mobility devices to approach...
-
National Council on Independent Living
The surface height we had recommended historically was 17 to 19 inches above the floor, which has been around for years in existing Standards....
- AJW Architectural Products UG120-U Series UG120-U 29" Swing-Up, 1.25" Diameter Grab Bar - Configuration U
- Macro Supa-Trac Heavy Duty Ground Surface
- Inpro Corporation ENDURANT® Trench Drain Receptor
- American Standard Acrylic Seated Safety Shower
- Unity Surfacing Systems Play-Land Safety Surfacing
-
F221.2.1.3 Other Boxes
The provision for seating in "other boxes" includes box seating provided in facilities such as performing arts auditoria where tiered boxes are designed for spatial and acoustical purposes...
-
Feature 4 - Routes to the Meeting Space
ADA Standards for Accessible Design | Temporary Barrier Removal Suggestions for Accessible Features It is important to note that people who are blind or have low vision may use all routes...
-
2. State and Local Laws
State and Local Laws The ADA does not override state or local laws designed to protect public health and safety, except where such laws conflict with ADA requirements....
-
Medical facilities
They recommended that whenever a correctional facility has a program that is addressed specifically in the 2004 ADAAG, such as a long-term care facility, the 2004 ADAAG scoping and design...
-
Convenience Food Restaurants
Industry comments expressed concern about a mandated design solution’s potential cost and the impact on drive-through communication devices. Response....
-
Technical Memorandum TM 2013-20 Valet Parking
The following excerpt from the “Guidance on the 2010 ADA Standards for Accessible Design” issued by the U.S....
-
Updates and Other Pocket Guides
notified when new Pocket Guides become available, when changes are made to this Pocket Guide or when new Standards are adopted by DOJ and other federal agencies as ADA, ABA, and/or Rehab Act design...
-
406 Curb Ramps
Rights-of-Way Access Advisory Committee, which was comprised of representatives from the transportation industry, Federal, State and local government agencies, the disability community, and design...
-
604.5 Grab Bars
In detention or correction facilities, grab bars shall not be required to be installed in housing or holding cells that are specially designed without protrusions for purposes of suicide...