Extensions shall not be required for continuous handrails at the inside turn of switchback or dogleg stairs and ramps. 2....
Search Results "State Requirement"
-
505.10 Handrail Extensions
- Aquatic Access Pool Lift IGAT-180/135
- Hamilton CapTel Captioned Telephone
- DORMA ED700 Low-Energy Swing Door Operator
- Ampetronic HLS02 Intercom & Information Point Audio Induction Loop Driver Hearing System
- Courtesy Direct Dial Handset Phones
- Corbin Russwin Inc. Access 600 RNE1 Electrified Door Hardware
- Handi-Ramp Galvanized Steel Ramps
- Bradley Contemporary Series Recess Mounted Soap Dispenser 6437
- Willoughby Industries Stainless Steel WODS ADA Outdoor Shower
- Yale 6400LN Series Grade 1 Cylindrical Locks
- Pilot Rock End Accessible Multi-Pedestal Table APT Series 3"x4" Recycled Plastic
- TownSteel ED6700 Narrow Stile Concealed Vertical Panic Device
-
11B-404.2.5 Thresholds
[2010 ADA Standards] EXCEPTION: Existing or altered thresholds ¾ inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required...
-
11B-222.2 Coat hooks and shelves
shelves are provided in individual compartments at least one of each type complying with Section 11B-803.5 shall be provided in individual compartments in dressing, fitting, or locker rooms required...
-
Transfer Steps: ADA Standard Section 1009.5.4
Where possible, the height of the transfer step should be minimized to decrease the distance an individual is required to lift up or move down to reach the next step to gain access....
-
Height: ADA Standard Section 1005.2.1
or sections 1012.2 and 1012.3 of the International Building Code (2003 edition) (incorporated by reference, see “Referenced Standards” in Chapter 1) is provided, the guard shall not be required...
-
BATHROOM
A compartmented bathroom is considered a single unit and is subject to the requirements of Chapters 11A and 11B....
-
11B-404.2.5 Thresholds
[2010 ADA Standards] EXCEPTION: Existing or altered thresholds ¾ inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required...
-
Clearance: ADA Standard Section 804.2
EXCEPTION: Spaces that do not provide a cooktop or conventional range shall not be required to comply with 804.2. Advisory 804.2 Clearance....
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
-
11B-222.2 Coat hooks and shelves
shelves are provided in individual compartments at least one of each type complying with Section 11B-803.5 shall be provided in individual compartments in dressing, fitting, or locker rooms required...
-
Assembly Area
For the purposes of these requirements, assembly areas include, but are not limited to, classrooms, lecture halls, courtrooms, public meeting rooms, public hearing rooms, legislative chambers...
-
11B-703.7.2.6.1 Men’s toilet and bathing facilities
Exception: Within secure perimeter of detention and correctional facilities, geometric symbols shall not be required to be ¼ inch (6.4 mm) thick....