Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground. Mirrors shall be full length with a reflective...
Search Results "Critical Care Patient Room"
Filters
Commonly Searched Documents
-
11B-803.6 Mirrors
-
11B-809.10 Toilet and bathing rooms
[See subsections ...]
-
5.8 Wheelchair Spaces Recommendations for M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair
5.8 Wheelchair Spaces Recommendations for M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair...
-
Are accessible passenger loading zones required on sites where no passenger loading zone is intended?
Accessible passenger loading zones are required at these sites whether or not passenger loading zones are planned: parking facilities that provide valet parking, licensed medical care and...
-
806 Transient Lodging Guest Rooms
806 Transient Lodging Guest Rooms...
-
M101.2 Application
Where diagnostic equipment is designed to support more than one patient position, the standards for each patient position supported shall be applied to the equipment....
-
Number of Accessible Guest Rooms
A hotel and motel trade group opposed any increase in the number of guest rooms required to be accessible and submitted a study it commissioned on the usage of such rooms....
-
4.1.2(5)(d)(ii)
(ii) Units and facilities that specialize in treatment or services for persons with mobility impairments: 20 percent of the total number of parking spaces provided serving each such...
-
11B-206 Accessible routes
Accessible routes shall be provided in accordance with Section 11B-206 and shall comply with Division 4. 11B-206.4.10 Medical care and long-term care facilities....
-
11B-224.1.2 Guest room doors and doorways
[2010 ADA Standards] 224.1.2 Guest Room Doors and Doorways....
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
This increases the room depth from Plan−1A....
-
M302.4.1 Clearance in Base
The base of the diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep...
-
M302.4.1 Clearance in Base
The base of the equipment shall provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum...
-
Scoping [4.1.3(21), 4.1.6(3)(h)]
Scoping [4.1.3(21), 4.1.6(3)(h)] ADAAG requires access to 5% of each "type" of dressing room in each location....
-
11B-222.3 Mirrors
Where mirrors are provided in dressing, fitting or locker rooms without individual compartments, at least one of each type shall comply with Section 11B-803.6....
-
11B-222.3 Mirrors
Where mirrors are provided in dressing, fitting or locker rooms without individual compartments, at least one of each type shall comply with Section 11B-803.6....
-
11B-222.3 Mirrors
Where mirrors are provided in dressing, fitting or locker rooms without individual compartments, at least one of each type shall comply with Section 11B-803.6....
-
Brewer Assist Power Procedure Table™
Brewer Assist Power Procedure Table™
-
11B-806.2.4 Toilet and bathing facilities
At housing at a place of education, the requirement that travel between fixtures does not require travel between other parts of the guest room shall have “guest room” interchangeable with...
-
11B-805.4.2 Equipment
Clear space complying with Section 11B-305.2 shall be provided as required for specific equipment.
-
M305.2.1 Location (Section-by-Section Analysis)
MDE Advisory Committee Report, 86, available at https://www.access-board.gov/guidelines-and-standards/health-care/about-this-rulemaking/advisory-committee-final-report....
-
803.4 Benches
A bench complying with 903 shall be provided within the room....
-
803.4 Benches
A bench complying with 903 shall be provided within the room....
-
Accessible Room Set-Up
Accessible Room Set-Up Once an accessible site is selected, it is essential that the meeting room furniture be arranged to allow everyone to fully participate....
