If compliance with this minimum height clearance requirement will cause the structure to exceed local height limitations imposed by local zoning, planning, or fire ordinances, or will result...
Search Results "Fire-Building Surface"
-
502.5 Vertical Clearance
-
11B-809.1 General
ETA Editor's Note: From DSA's "Summary of New and Amended 2025 California Building Code (CBC) Regulations for Accessibility in the Triennial Code Cycle": "Section was amended to clarify...
-
11B-221.2.1.6 Specialty seating areas
Exception: In existing buildings and facilities, if it is not readily achievable for wheelchair spaces to be placed in each specialty seating area, those services or amenities shall be provided...
-
11B-221.2.1.6 Specialty seating areas
Exception: In existing buildings and facilities, if it is not readily achievable for wheelchair spaces to be placed in each specialty seating area, those services or amenities shall be provided...
-
1007.3.2 Golf Club Reach Range Area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. Figure 1007.3.2 Golf Club Reach Range Area ...
-
Grab Bars
The top of the gripping surface must be 4 to 6 inches above the wall to provide leverage to the person using the bars....
-
1012.2 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
Protruding Objects [1016.9]
To prevent injuries to people who are blind or have low vision, whenever possible, maintain the vertical clearance free of tree branches a minimum of 80 inches above the ground surface along...
-
Signs
Standards) § 4.1.3(16)(a): Raised and Braille letters or numbers (Standards § 4.30.4); Mounting location (§ 4.30.6); Color contrast (§ 4.30.5); and Non-glare surface...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
4.16.3 Height
Whereas the rationale for seat height in ADAAG is to provide a surface that is at or slightly below the wheelchair seat in order to accommodate a sliding transfer, the rationale in eldercare...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
-
11B-809.10.5.1 Clear floor space
The edge of the clear floor space shall be flush with the control wall surface....
-
11B-812.7.2 Marking
The color of the borderlines, hatched lines, and letters shall contrast with that of the surface of the access aisle....
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
1009.4.5 Grab Bars
The top of the gripping surface shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above transfer walls....
-
606.3 Height
Lavatories and sinks shall be installed with the front of the higher of the rim or counter surface 34 inches (865 mm) maximum above the finish floor or ground. EXCEPTIONS: 1....
-
"Wheelchair" (Section-by-Section Analysis)
"Typical indoor and outdoor pedestrian areas" refer to locations and surfaces used by and intended for pedestrians, including sidewalks, paved paths, floors of buildings, elevators, and...
-
"Wheelchair" (Section-by-Section Analysis)
"Typical indoor and outdoor pedestrian areas" refer to locations and surfaces used by and intended for pedestrians, including sidewalks, paved paths, floors of buildings, elevators, and...
-
Function Keys
It included specifications for key surfaces to be raised 1/25 inch minimum and that outer edges have a radius of 1/50 inch maximum (707.4.2)....
-
Step 2: Identify the Presence of Limiting Factors
What sort of surface is firm and stable? If the answer to both of the following questions is yes, the surface is probably firm and stable....