greater than 10 and it is determined that compliance with Section 1133B.2.3 would create an unreasonable hardship, a projection of 5/8 inch (16 mm) maximum will be permitted for the latch side...
Search Results "Side Transfer Surface"
Filters
Commonly Searched Documents
-
1133B.2.3.2
-
4.3.5 Patient Positions During Diagnostic Imaging
4.3.5 Patient Positions During Diagnostic Imaging Finally, the vast majority of diagnostic imaging exams are conducted while patients are supine, prone, or side-lying on the table....
-
Element-by-element safe harbor for public accommodations. (Section-by-Section Analysis)
Because there are valid arguments on both sides of this issue, the Department sought public comment on this issue in its ANPRM....
-
2.1 Participants’ Vision
This group is shown by the “N” label on the left side of the abscissa to indicate that their contrast sensitivity was not measurable with this test....
-
1010.1.9.7 Delayed egress locks
An attempt to egress shall initiate an irreversible process that shall allow such egress in not more than 15 seconds when a physical effort to exit is applied to the egress side door hardware...
-
Issue 1: APS volume
Note that nearby building facades or other hard surfaces that reflect the APS signal may actually cause the APS to increase in volume in reaction to its own sound, if the sound or ambient...
-
Accessible Means for Gathering Feedback
., the desk must be on an accessible route and have a writing surface at the required height or a clipboard available for people who use wheelchairs)....
-
Back Support
In addition, clarification has been added that the dimensions for back support are measured from the surface of the seat. Comment....
-
1131B.2, Item 1
Vehicle standing spaces and access aisles shall be level with surface slopes not exceeding one unit vertical in 50 units horizontal (2-percent slope) in all directions....
-
Observations:
The wheelchair scale we used had a leveled surface of length 30 in. long with a bevel of 5 in. each at both ends (i.e., total length of 40 in.)....
-
Mobility
Typical problems include maneuvering through narrow spaces, going up or down steep paths, moving over rough or uneven surfaces, using toilet and bathing facilities, reaching and seeing items...
-
11B-606.2 Clear floor space
clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter surface...
-
TABLE OF CONTENTS
Buildings: Alterations. 4.1.7 Accessible Buildings: Historic Preservation 4.2 Space Allowance and Reach Ranges 4.3 Accessible Route 4.4 Protruding Objects 4.5 Ground and Floor Surfaces...
-
11B-606.2 Clear floor space
clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter surface...
-
11B-606.2 Clear floor space
clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter surface...
-
Gamco Recessed Towel Dispenser - TD-4
Description Unit fabricated of type 304 stainless steel with exposed surfaces having a #4 satin-finish....
-
Gamco Recessed Mini-Towel Dispenser and Waste Receptacle Combination - TW-3
All welded construction with all exposed surfaces having a #4 satin finish. One piece seamless flange provided with 1/4" (6mm) return for rigidity....
-
HEWI Polymide Pull Handles
The polyamide surface is warm to touch and is therefore particularly pleasant to grip. HEWI push handles made of polyamide are reinforced inside by a corrosion-proof steel core....
-
Spectrum Aquatics Access Ramp
Features 15' ramp length provides ease of entry and egress for patrons 36" wide structural fiberglass T-Bar slip-resistant surface Custom fabricated to each pool...
-
AJW Architectural Products U480 Round Waste Chute - Vanity Mounted
steel with a bright polished finish Waste receptacle is vanity mounted Product Specs Waste Chute: Fabricated of #22 ga stainless steel with a bright polished finish on all exposed surfaces...
-
Panda TS.75 Aluminum Wood Clad Thermally Broken Folding Door System
Sealing the windows/doors with equal coats of finish on both sides and all edges within one week from delivery is necessary to minimize moisture absorption. ...
-
TownSteel VRH Ligature Resistant Hook
institutions 14 gauge heavy duty 18-8 S, type-304 stainless steel back plate Stainless steel pivoting ball joint releases when over 10lbs of force applied Pivoting ball tension adjustable Surface...
-
Mockett DH403-BB Square Bar Door Handle Back to Back
Leather bound handles with 1” square body make for an easy grip surface. Classic look in a stunningly modern design. Sold as a set of 2. Back to back mounting hardware included....
-
BEA Inc. PBJMS Series Jamb Push Plate (Push to Open)
Universal touch area at any “push” location Stainless steel finish is scratch/scuff resistant and will not deteriorate or rust Text and logo are baked onto the surface...
