Water closet seats shall be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat above the finish floor....
Search Results "Lavatory Clear Floor Space"
Commonly Searched Documents
-
11B-809.10.7.4 Seat height
-
Parking at Residential Facilities
Where parking spaces are provided for each dwelling unit, at least one parking space for each accessible dwelling unit is required to be accessible (208.2.3.1)....
-
Sharing an Access Aisle
Two spaces are permitted to share an access aisle. The proposed rule, consistent with the original ADAAG, allowed access aisles to be provided on either side of the parking space....
- Verifone MX 925 Point of Sale Machine with Credit Card Reader
- Mockett PCS38-94 Clamp-On Power Grommet
-
Other international standards
TR 34 Concrete Industrial Ground Floors—Specification and Control of Surface Regularity of Free Movement Areas, UK Concrete Society (provides for three classes of industrial surfaces...
-
210 and 504 Stairways
210 and 504 Stairways The 1991 Standards require stairs to be accessible only when they provide access to floor levels not otherwise connected by an accessible route (e.g., where the...
-
1136A.1 Receptacle heights
inches (1219 mm) measured from the top of the receptacle outlet box nor less than 15 inches (381 mm) measured from the bottom of the receptacle outlet box to the level of the finished floor...
-
1010.1.7 Thresholds
Thresholds at doorways shall not exceed ¾ inch (19.1 mm) in height above the finished floor or landing for sliding doors serving dwelling units or ½ inch (12.7 mm) above the finished floor...
-
III-7.4300 Parking
For example, only four percent of the spaces in a 100-space lot must be accessible. Certain facilities, however, are subject to higher requirements....
-
§382.9(d)
provision of this part, and that the carrier has provided an effective alternative means of achieving the objective of the provisions of this part subject to the waiver or have demonstrated by clear...
-
404.3.6 Break Out Opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (815 mm) minimum when operated...
-
404.3.6 Break Out Opening
Where doors and gates without standby power are a part of a means of egress, the clear break out opening at swinging or sliding doors and gates shall be 32 inches (815 mm) minimum when operated...
-
Define "task." (Section-by-Section Analysis)
The Department feels that the common definition of task is sufficiently clear and that it is not necessary to add to the definitions section. ...
-
2.5.3 Width
Where resting intervals are provided adjacent to an outdoor recreation access route, the resting interval clear width shall be 36 inches (915 mm) minimum. ...
-
Islands [§406.7]
Islands [§406.7] A 48” min. long separation is necessary between curb ramps so that people using wheelchairs can clear one ramp before negotiating the next....
- Willoughby Industries US-HC Cabinet Shower
- Neo-Metro Euro-Urban Toilet Configured for In-Wall Flushing System
-
The Presentation Area / Speaker’s Platform Design and Considerations
Space for a qualified interpreter for people who are Deaf or hard of hearing should be included in all plans, and seating nearest interpreters should be reserved for individuals using those...
-
Required Compliance [§206.6]
Facility or Space Elevator Type Permitted (if provided instead of ramp) Facilities required to provide an accessible route to stories/ mezzanines Elevator (§407...
-
11B-608.10 Soap dish
Where a soap dish is provided, it shall be located on the control wall at 40 inches (1016 mm) maximum above the shower floor, and within the reach limits from the seat....
-
407.3.3.1 Height
The device shall be activated by sensing an obstruction passing through the opening at 5 inches (125 mm) nominal and 29 inches (735 mm) nominal above the finish floor....
-
904.5.2 Tray Slides
The tops of tray slides shall be 28 inches (710 mm) minimum and 34 inches (865 mm) maximum above the finish floor or ground. [ECTCR UFAS 5.2]...
-
1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (280 mm) minimum and 18 inches (455 mm) maximum measured to the top of the surface from the ground or floor surface....