That paragraph provides that a store with check-out aisles must ensure that an adequate number of accessible check-out aisles is kept open during store hours, or must otherwise modify its...
Search Results "Access Aisle Width"
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Section-By-Section Analysis and Response to Comments)
-
Requirement 5. Light switches, electrical outlets, thermostats and other environmental controls in accessible locations.
Section 100.205(c)(3)(ii) requires that all covered multifamily dwellings with a building entrance on an accessible route shall be designed and constructed in such a manner that all premises...
-
11B-235.2 Boat slips
TABLE 11B-235.2 BOAT SLIPS TOTAL NUMBER OF BOAT SLIPS PROVIDED IN FACILITY MINIMUM NUMBER OF REQUIRED ACCESSIBLE BOAT SLIPS...
-
11B-235.2 Boat slips
TABLE 11B-235.2 BOAT SLIPS TOTAL NUMBER OF BOAT SLIPS PROVIDED IN FACILITY MINIMUM NUMBER OF REQUIRED ACCESSIBLE BOAT SLIPS...
-
§ 36.308(b) New construction and alterations
The provision and location of wheelchair seating spaces and companion seats and designated aisle seats in newly constructed or altered assembly areas shall be governed by the standards for...
-
Edge Protection
ADAAG addresses drop-offs along ramps and ramp landings but not along other portions of accessible routes or circulation paths....
-
11B-603.2.3 Door swing
Doors to accessible water closet compartments shall be permitted to encroach into the turning space without limitation....
-
11B-603.2.3 Door swing
Doors to accessible water closet compartments shall be permitted to encroach into the turning space without limitation....
-
1012.1 General
The technical requirements address the width of parking spaces and pull-up spaces for recreational vehicles (1012.2); the width of parking spaces for vehicles, other than recreational vehicles...
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
11B-703.2.7 Character spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
11B-703.2.7 Character spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
11B-809.8.3 Door maneuvering clearance.
The width of the maneuvering clearance shall extend 18 inches (457 mm) beyond the strike edge at the pull side of the door....
-
1. Thigh Breadth
Thigh Breadth Thigh breadth was used to provide an estimate of the width of the seating surface....
-
H.4.i. - Does presentation equipment procured have to meet the Access Board standards?
Presentation equipment, such as LCD data projectors and laptop computers, are considered EIT and therefore covered by the Access Board's standards, unless an exception applies....
-
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA AND THE CITY OF CHESAPEAKE REGARDING THE ACCESSIBILITY OF POLLING PLACES
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA AND THE CITY OF CHESAPEAKE REGARDING THE ACCESSIBILITY OF POLLING PLACES This settlement agreement (the "Agreement") is entered...
-
B.2.i. - What must an agency do to ensure its' acquisitions of EIT provide "comparable access"?
Unless an exception applies, an agency’s obligation to provide comparable access under Section 508 is satisfied by acquiring EIT that meets the applicable technical provisions in Subparts...
-
36 CFR Parts 1190 and 1191 ADA and ABA Accessibility Guidelines - Preamble (Discussion of Comments and Changes)
Guidelines for Buildings and Facilities; Architectural Barriers Act (ABA) Accessibility Guidelines Preamble (Discussion of Comments and Changes) __________________________________...
-
Protruding Objects
., fire extinguishers, telephones) shall protrude no more than 4 inches into walks, halls, corridors, passageways, aisles, or any other areas where a person walks....
-
M301.4.1 Clearance in Base (Section-by-Section Analysis)
Where the width of the equipment is less than 36 inches wide, the proposed rule required the clearance to extend the full width of the equipment. Id....
-
Horizontal Dispersion: ADA Standard Section 221.2.3.1
Section 221.2.3.1 covers scoping requirements in the current ADA Standards for horizontal Dispersion in assembly areas.