As augmentative tools for work and living enhancement, and social participation, these technologies should be not only usable, but also be accessible and inclusive for people with disabilities...
Search Results "Access Aisle Width"
Filters
Commonly Searched Documents
-
Wireless RERC: Accessibility, Usability, and the Design of Wearables and Wirelessly Connected Devices
-
1133B.2.3.2
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.3.2 Automatic and power-assisted doors. ...
-
D.2. - Must requiring officials consider all the Access Board’s technical provisions and functional performance criteria each time they purchase EIT?
Requiring officials need only consider all applicable technical provisions from the Access Board’s standards to ensure acquired products provide comparable access (see section B.2.ii, above...
-
Automatic Door Break Out Openings
The minimum clear opening width for automatic doors is measured with all leaves in the open position....
-
Changes in Level at Entry to Wheelchair Spaces (M303.3)
The technical criteria are consistent with the 2004 ADA and ABA Accessibility Guidelines. Level changes up to ¼ inch high are permitted to be vertical....
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
Unless the required number of accessible ground level play components are provided, the new play component would be required to be accessible....
-
1009.5.1 Transfer Platform
Transfer platforms shall provide 19 inches (485 mm) minimum clear depth and 24 inches (610 mm) minimum clear width. Figure 1009.5.1 Size of Transfer Platform...
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
R308.1.1.1 Dimensions
Boarding and alighting areas shall provide a clear length of 2.4 m (8.0 ft) minimum, measured perpendicular to the curb or street or highway edge, and a clear width of 1.5 m (5.0 ft) minimum...
-
2. Using the Tape Measure
Using the Tape Measure A metal tape measure is needed to measure the length, width, height, and depth of various elements....
-
[A] PUBLIC WAY
other parcel of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width...
-
PUBLIC WAY
other parcel of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width...
-
International Code Council (ICC): Become an ICC Certified Accessibility Inspector/Plans Examiner
Demands for Accessible Buildings Are Growing: Become an ICC Certified Accessibility Inspector/Plans Examiner now The 2010 U.S....
-
Re: Single User Restroom Accessibility
Section 11B-202.3.2 indicates that "an alteration of an existing element, space, or area of a building or facility shall not impose a requirement for accessibility greater than new construction...
-
11B-407.4.1 Car dimensions
Inside dimensions of elevator cars and clear width of elevator doors shall comply with Table 11B-407.4.1....
-
M302.2.4 Transfer Sides (Section-by-Section Analysis)
diagnostic equipment used by patients in the seated position required transfer surfaces to have the option to transfer from a mobility device onto one short side (depth) and one long side (width...
-
1017.5 Tread Obstacles
The frequency of tread obstacles and tread obstacles that cross the full width of the trail tread can make travel difficult for individuals who use wheeled mobility devices....
-
11B-705.2 Detectable directional texture
The width of the directional texture shall be equal to the width of the transit vehicle’s door opening. The depth of the texture shall not be less than 36 inches (914 mm)....
-
221.9 Stadium Style Movie Theaters
Wheelchair spaces and companion seats shall be located on a riser or cross-aisle in the stadium section that satisfies at least one of the following criteria: (i) It is located within the...
-
Section 36.308 Seating in Assembly Areas (Preamble, Section-by-Section Analysis)
users who wish to transfer to existing seating, paragraph (a)(1) of the final rule adds a requirement that, to the extent readily achievable, a reasonable number of seats with removable aisle-side...
-
Section 36.308 Seating in Assembly Areas (Section-By-Section Analysis and Response to Comments)
users who wish to transfer to existing seating, paragraph (a)(1) of the final rule adds a requirement that, to the extent readily achievable, a reasonable number of seats with removable aisle-side...
-
Figure 610.3 Extent of Seat – Drawing from the U.S. Access Board
-
Figure 405.7 Ramp Landings – Drawing from the U.S. Access Board
-
Figure 307.4 Vertical Clearance – Drawing from the U.S. Access Board
