of this part is to implement the Air Carrier Access Act of 1986 (49 U.S.C. 41705), which provides that no air carrier may discriminate against any otherwise qualified individual with a disability...
Search Results "ADCP: Airport Disability Compliance Program"
-
§ 382.1 Purpose
-
Sec. 469.001(c)
(c) This chapter is intended to further the policy of this state to encourage and promote the rehabilitation of persons with disabilities and to eliminate, to the extent possible, unnecessary...
-
12206(b) Agency and public assistance
Agency and public assistance The Attorney General may obtain the assistance of other Federal agencies in carrying out subsection (a) of this section, including the National Council on Disability...
-
§ 36.303(g)(6)(i)
(i) A public accommodation may meet its obligation to provide captioning and audio description in its movie theaters to persons with disabilities through any technology so long as that technology...
-
American Specialties 9013 Recessed Stainless Steel Baby Changing Station
For compliance with 2010 ADA Accessibility Standards, install unit so that top edge of changing table is 32" to 32-3/8" (813 to 822) above finished floor (AFF)....
-
Smith System Trespa Planner Science Table 48″ Deep
A science classroom demands compliance with strict codes and standards....
-
Bradley 643 Standard Series Horizontal Recessed Soap Dispenser
Conformity and compliance to local and national codes is the responsibility of the installer....
-
American Safety Tread Co., Inc. Type T-24H Contrasting Stripe
Barrier Free: The designs shown are in compliance with the Barrier-Free Code, ensuring those physically impaired complete access to public buildings....
-
F238.2.1 Teeing Grounds
courses, the forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance...
-
Reach Range
Compliance with the reach range requirement when the door is fully open would severely impact the design and size of such appliances. Response....
-
H. How Can You Tell if a Curb Ramp is Accessible?
To assist you, the next installment of this Tool Kit will include instructions on how to survey curb ramps for compliance with the ADA Standards and a Curb Ramps survey form for use in conducting...
-
F233.4.4 Alterations
EXCEPTION: Where compliance with 809.2, 809.3, or 809.4 is technically infeasible, or where it is technically infeasible to provide an accessible route to a residential dwelling unit, the...
-
611 Washing Machines and Clothes Dryers
Commenters indicated that compliance with the proposed specification would reduce machine capacity and would be difficult to achieve. Response....
-
810.2.2 Dimensions
Note to Reader: The Department of Transportation’s ADA standards indicate that compliance is required to the extent construction specifications are within a public entity's control: 810.2.2...
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
The MDE NPRM proposed requiring standing supports on each side of the standing surface of diagnostic equipment used by patients in the standing position, and compliance with the technical...
-
Administrative Provisions
◼ Airlines must obtain an assurance of compliance from contractors who provide services to passengers....
-
Clear Width [1016.3]
The 36-inch-minimum clear width must be maintained for the entire ORAR and may not be reduced by gates, barriers, or other obstacles unless a condition for exception does not permit full compliance...
-
Using the Beach Access Route Exceptions [1018.1, Exceptions 1 and 2]
When a condition for exception does not permit full compliance with a specific provision in the technical requirements on a portion of a beach access route, that portion of the route must...
-
238.2.1 Teeing Grounds
courses, the forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance...
-
233.3.4 Alterations
EXCEPTION: Where compliance with 809.2, 809.3, or 809.4 is technically infeasible, or where it is technically infeasible to provide an accessible route to a residential dwelling unit, the...
-
General (R304.1) (Section-by-Section Analysis)
In alterations where existing physical constraints make it impractical to fully comply with the technical requirements, compliance is required to the extent practicable within the scope...
-
Toilet Compartments
To achieve compliance with TAS for both the toilet compartment and baby changing table, it may be necessary to design the toilet compartment to exceed the minimum size requirements of TAS...
-
22. Enforcement
To the extent individual members of the Settlement Class have complaints regarding the City’s compliance with the terms of this Settlement Agreement, they must bring them to the attention...
-
Enforcement Mechanisms
on other possible enforcement mechanisms, such as a preconstruction review process, certification by a licensed architect, engineer or other building professional that a project is in compliance...
