Call buttons in elevator lobbies and halls shall be centered at 42 in (1065 mm) above the floor. Such call buttons shall have visual signals to indicate when each call is registered...
Search Results "Ramp Landing"
Filters
Commonly Searched Documents
-
4.10.3 HALL CALL BUTTONS
-
11B-407.2.1.5 Signals
Call buttons shall have visible signals that will activate when each call is registered and will extinguish when each call is answered. Call buttons shall be internally illuminated...
-
11B-407.2.1.5 Signals
Call buttons shall have visible signals that will activate when each call is registered and will extinguish when each call is answered. Call buttons shall be internally illuminated...
-
Q3: Roadway Resurfacing Alteration Project and Curb Ramp Improvements
Q3: If a roadway resurfacing alteration project does not span the full width of the road, do I have to put in curb ramps?...
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
1008.2.5.1 Ground Level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
1008.2.5.1 Ground Level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
Roadway resurfacing, curb ramps at crosswalks
If roadways are being resurfaced or otherwise altered as part of a BRT project, curb ramps must be installed at crosswalks that have been affected. (DOT ADA Standard 106.5.)...
-
1008.2.5.1 Ground Level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
6. Ramps
Ramps 4.8 Accessible routes with slopes greater than 1:20....
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
-
Fittings: ADA Standard Section 505.9
Section 505.9 covers the current ADA Standards for handrail fittings.
-
11B-505.9 Fittings
Handrails shall not rotate within their fittings.
-
§ 38.95(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
-
9. When ramp access is provided to one side of a crawl tube and the other side is only entered by transfer access, how is it counted (ramp or transfer access play component)?
When ramp access is provided to one side of a crawl tube and the other side is only entered by transfer access, how is it counted (ramp or transfer access play component)?...
-
1.1.12 Ramp cross slope
1.1.12 Ramp cross slope....
-
§ 38.125(c) Car ramp or bridge plate
(c) Car ramp or bridge plate—...
-
Width [4.7.3] and Surface [4.7.4]
The minimum clear width of a curb ramp is 36 inches, exclusive of flared sides....
-
Q7: Curb Ramp for a Sidewalk that is Not Made of Concrete or Asphalt
Q7: Is a curb ramp required for a sidewalk that is not made of concrete or asphalt?...
-
T204.2 Doorways with Lifts, Ramps or Bridgeplates
Doorways with lifts or ramps shall comply with T502.2....
-
GameTime ADA Wide Ramp Attachment 3D
without mobility devices Benefits Adds an accessible method of entry/exit to and from the play structure Includes a threshold for smooth transitions on and off the ramp...
-
§ 38.23(c)(8) Handrails
grasp them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp...
