Water spouts at water hydrants and water utility hook-ups shall be 28 inches (710 mm) minimum and 36 inches (915 mm) maximum above the ground.
Search Results "CSI: Construction Specification Institute"
Filters
Commonly Searched Documents
-
1011.6 Water Spouts
-
1.1.10 Ramps
1.1.10 Ramps. Measure accessible ramps for overall running slope and cross slope as well as local running slope and cross slope variations (flatness) in accordance with Sections...
-
1.1.14 Flatness of ramp cross slope
1.1.14 Flatness of ramp cross slope. For ramps, measure flatness of cross slope by placing a 24 - in. (600 mm) digital inclinometer perpendicular to the line of travel at 4 ft (1200...
-
1.1.16 Alternate measurement tools
1.1.16 Alternate measurement tools. Ramps may be measured with instruments other than a digital inclinometer if they provide the data required for evaluation of tolerances as given...
-
1.1.6 Flatness of walk cross slope
1.1.6 Flatness of walk cross slope. For walks and other pedestrian paths, measure flatness of the cross slope by placing a 24 - in. (600 mm) digital inclinometer perpendicular to the...
-
Kompan, Inc. M243P - Crocodile Bench
Requires the Premium User plan or above. (Login or upgrade your account!) -
11B-201.1 Scope, 11B-201.2 Application based on building or facility use, 11B-202.2 Additions, 11B-202.3 Alterations
The altered element or space, and the specific area of alteration, is the two CT scan rooms....
-
Section 4. Application of the Guidelines
The design specifications (guidelines) presented in Section 5 apply to new construction of "covered multifamily dwellings", as defined in Section 2....
-
II. GENERAL NONDISCRIMINATION REQUIREMENTS
Failing or refusing to design and construct QuikTrip Stores that are readily accessible to and usable by individuals with disabilities in full compliance with 42 U.S.C. § 12183(a)(1), 28...
-
Facility
Facilities must comply with all 2010 ADA Standards for Accessible Design for new construction and remodeling projects....
-
Education's Intent To Revise its Section 504 Regulations To Adopt the 2010 Title II ADA Standards
regulation, DOJ stated that Federal agencies that extend Federal financial assistance should revise their Section 504 regulations to adopt the 2010 Standards as Section 504 standards for new construction...
-
3. If I comply with the California accessibility requirements, am I in compliance with ADA?
Remember that the accessibility requirements are reviewed by the building department only when a project is submitted for permit (meaning when you design, construct, alter, remodel, add,...
-
DSA IR 11B-8 - USE OF PREDETERMINED CONSTRUCTION TOLERANCE GUIDELINES FOR ACCESSIBILITY (with revisions issued through Jan. 2011)
Interpretation of Regulations Document IR 11B-8 USE OF PREDETERMINED CONSTRUCTION TOLERANCE GUIDELINES FOR ACCESSIBILITY References: 2007/2010 California Building Code, Section...
-
Structural Impracticability—28 CFR 35.151
Under § 35.151(a)(2) full compliance with the requirements of the 2010 Standards is not required in new construction where a public entity can demonstrate that it is structurally impracticable...
-
1.1.7.2 Specific provisions
Where a specific provision varies from a general provision, the specific provision shall apply....
-
Fire Rings, Grills, Fireplaces, and Wood Stoves
However, if a condition for exception in an alteration project at an existing site prohibits full compliance with a specific requirement for clear floor or ground space (surface, slope,...
-
B. 2004 ADA and ABA Accessibility Guidelines
Until HUD adopts a new accessibility standard, HUD recipients who undertake alterations or new construction of a project may continue to utilize UFAS and HUD’s Section 504 or ABA regulations...
-
ADA & Level Boarding - When Does Section 37.42 begin to apply?
49 CFR §37.42(a) DECEMBER 14, 2011
-
Sec.36.401(d)(2)(ii)
(ii) A terminal, depot, or other station used for specified public transportation, or an airport passenger terminal. In such a facility, any area housing passenger services,...
-
§100.205(e)
(e)
-
1.1.7 Measurement of parking areas
1.1.7 Measurement of parking areas. Only accessible access aisles and passenger loading zones that are part of a larger parking area need to be measured. These areas should be...
-
1.1.5 Flatness of walk running slope
1.1.5 Flatness of walk running slope. For pedestrian paths up to and including 6 ft (1.8 m) wide, measure for flatness of the running slope at 10 ft (3 m) increments along the...
-
A. Section 504
504 regulation prohibit discrimination on the basis of disability in any program or activity that receives Federal financial assistance from the Department.3 HUD’s Section 504 regulation specifically...
-
Compliance Determinations by State and Local Jurisdictions
The commenters noted that (1) 100.205(g) encourages States and units of general local government to include, in their existing procedures for the review and approval of newly constructed...
