Cover Finish Mounting Time Cycle Dryer Type XL-BW White Thermoset (BMC) Surface...
Search Results "Extended Floor Surface"
Commonly Searched Documents
- Excel Dryer, Inc. XLERATOR® Hand Dryers
- Mohawk Group Kinesthetic Carpet Tiles
- Mohawk Group Into It Tile Carpet Tiles
- Mohawk Group Write Direction Carpet Tiles
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
For example, floors above or below the accessible ground floor must meet the requirements of this section except for elevator service....
-
Other Contrast Attributes
Response by [Participant]: You’re going to feel the difference between the smooth surface and a soft surface or a textured surface....
-
Reach Ranges
The 1991 Standards set the maximum height for side reach at 54 inches above the floor....
-
TABLE 601 FIRE-RESISTANCE RATING REQUIREMENTS FOR BUILDING ELEMENTS (hours)
0 0 Nonbearing walls and partitions Exterior Interiore See Table 602 See Section 602 Floor...
-
SUMMARY OF THE 19-INCH RECOMMENDATION
Access Board’s Medical Diagnostic Equipment Technical Advisory Committee discussed transfer surface height extensively....
-
Mobility
And the changes in surface elevation – ramps on sidewalks – these types of things....
-
Grab bars
This standard gives the grab bar height range of 4 to 6 inches from the wall to the top of the gripping surface....
-
Engineered vs. Outside (Questionnaire Results)
Tables 8 and 9 and Figures 22 and 23 show the questionnaire results broken down by engineered and outdoor surfaces....
-
Voting Area
If voters are expected to vote at counters or tables, there should be a writing surface that provides knee and toe clearance so that a voter who uses a wheelchair may sit at and use the...
-
Issue 9: Reach (how far?)
The APS shown in Figure 13 are appropriately located within the landscape strip, reachable from a paved level surface, and aligned with the crosswalk lines....
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
Similarly, the surfaces of ceramic tiles that form the wall behind a grab bar will not be perfectly flat due the manufacturing processes that make them. ...
-
Seats
The deck surface between the centerline of the seat and the pool edge cannot have a slope greater than 1:48....
-
R105 Definitions (Section-by-Section Analysis)
ramp, element, facility, grade break, operable part, pedestrian access route, pedestrian circulation path, public right-of-way, qualified historic facility, running slope, and vertical surface...
-
Supporting Documents for the Medical Diagnostic Equipment Accessibility Standards Advisory Committee Report
Chairs Subcommittee Report - Imaging Equipment Subcommittee Report - Mammography Subcommittee Report - Stretchers Subcommittee Report - Weight Scales IDeA Center Memo – Transfer Surface...
-
FEATURES
Beds, stretchers, and other types of equipment will have unique features that determine the shapes of their patient support surfaces....
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Temporary Suspension
reflecting pools [4.29.6] Detectable warnings are not prohibited by this suspension; jurisdictions may continue to install the truncated domes specified in ADAAG or other surfaces...
-
Landings [4.8.4]
It is recommended that landings of exterior ramps be drained so that water does not accumulate on the surface....
-
C. Defendants' Transaction Counter
But “[b]ecause of the cash registers and merchandise displays . . . defendant does not provide a 36-inch-long clear counter surface.” Id....