Where existing elements or spaces are altered, each altered element or space shall comply with the applicable requirements of Division 2, including Section 11B-202.4....
Search Results "Comply With"
-
11B-202.3 Alterations
-
11B-703.8.6 Stroke width
Low resolution VMS characters shall comply with the pixel count for stroke width in Table 11B-703.8.5....
-
607.5 Controls
Controls shall comply with 309.4. Figure 607.5 Bathtub Control Location...
-
11B-216.4.4 Delayed egress locks
Signs required by Chapter 10, Section 1008.1.9.7, item 5.1 at doors with delayed egress locks shall comply with Sections 11B-703.1 _|Signs; General|_ 11B-703.2 _|Signs; Raised Characters...
-
11B-232.2.2 Cells with communication features
general holding cells and general housing cells equipped with audible emergency alarm systems and permanently installed telephones within the cell shall provide communication features complying...
-
§ 1194.22(k)
(k) A text-only page, with equivalent information or functionality, shall be provided to make a web site comply with the provisions of this part, when compliance cannot be accomplished in...
-
F206.7 Platform Lifts
Platform lifts shall comply with 410. Platform lifts shall be permitted as a component of an accessible route in new construction in accordance with F206.7....
-
F208.2.3.2 Additional Parking Spaces for Residents
each residential dwelling unit exceeds one parking space per residential dwelling unit, 2 percent, but no fewer than one space, of all the parking spaces not covered by F208.2.3.1 shall comply...
-
Sec. 469.106(d)
(d) If an inspection under Subsection (c) determines that a building or facility does not comply with all applicable standards and specifications, the leasing agency or the Texas Building...
-
Pedestrian Signal Phase Timing (Section-by-Section Analysis)
Pedestrian Signal Phase Timing (Section-by-Section Analysis) Pedestrian signal phase timing must comply with referenced MUTCD standards and use a pedestrian clearance time that is calculated...
-
R409.7 Cross Section
Handrail gripping surfaces shall have a cross section complying with R409.7.1 or R409.7.2....
-
§27.129(f)(1)
Federal financial assistance if it satisfies the terms and conditions of that order or if it brings itself into compliance with this part and provides reasonable assurance that it will fully comply...
-
11B-608.1 General
Shower compartments shall comply with Section 11B-608. [2010 ADAS] Advisory 608.1 General. ...
-
11B-403.5 Clearances
Walking surfaces shall provide clearances complying with Section 11B-403.5....
-
4.3.4 Tent Pad or Platform Surface
Where a condition for exception in section 1.1 prohibits full compliance, the surface shall comply with 4.3.4 to the extent practicable....
-
6.3(1)
(1) Each bedroom shall have a door that complies with 4.13....
-
4.19.2 Height and Clearances
Knee and toe clearance shall comply with Fig. 31....
-
4.17.5* Doors
Toilet stall doors, including door hardware, shall comply with 4.13....
-
10.3.3(1)
(1) For the purpose of complying with 4.1.6(2) Alterations to an Area Containing a Primary Function, an area of primary function shall be as defined by applicable provisions of 49 C.F.R....
-
4.29.5 Detectable Warnings at Hazardous Vehicular Areas
railings, or other elements between the pedestrian areas and vehicular areas, the boundary between the areas shall be defined by a continuous detectable warning which is 36 in (915 mm) wide, complying...
-
4.3.4 Tent Pad or Platform Surface
Where a condition for exception in section 1.1 prohibits full compliance, the surface shall comply with 4.3.4 to the extent practicable...
-
2.4.2
2.4.2 When defining acceptable methods of correction for a non - complying element, give reasonable consideration to how the remedial action may affect construction time, cost, adjacent...
-
11B-411.2.1.2.4 Display screen
The display screen shall comply with Section 11B-411.2.1.2.4....
-
11B-703.8.6 Stroke width
Low resolution VMS characters shall comply with the pixel count for stroke width in Table 11B-703.8.5....