be permitted to be located perpendicular to the boat slip and shall extend the width of the boat slip, where the facility has at least one boat slip complying with 1003.3, and further compliance...
Search Results "ADA Compliance"
-
1003.3.1 Boat Slip Clearance
-
UNREASONABLE HARDSHIP
When the enforcing agency finds that compliance with the building standard would make the specific work of the project affected by the building standard infeasible, based on an overall evaluation...
-
Executive Summary
Executive Summary Provisions of Section 4203 of the Patient Protection and Affordable Care Act (ACA) require the Architectural and Transportation Barriers Compliance Board (U.S....
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
Doors which meet conditions described in this Technical Memorandum will be in compliance with TAS 404.2.10. The illustration depicts the intent of TAS 404.2.10....
-
Letter from The Assistant Secretary
The attached resource guide reminds all educational institutions receiving Federal financial assistance from the Department that they must vigilantly work to ensure compliance with Section...
-
Retaliation
Individuals should be commended when they raise concerns about compliance with the Federal civil rights laws, not punished for doing so. 143 34 C.F.R. § 104.61....
-
Utilities at Recreation Sites
However, if a condition for exception in an alteration project at an existing site prohibits full compliance with a specific requirement for clear floor or ground space (surface, slope,...
-
General [4.5.1]
ADAAG does not require compliance with a specified level of slip-resistance since the static coefficient of fiction, which can be measured in several ways, varies according to the measuring...
-
C. Training
(b) how to resolve errors in the implementation of temporary measures on Election Day; (c) how to document the implementation of temporary measures on Election Day using checklists or compliance...
-
Tread Obstacles on Outdoor Recreation Access Routes
Although these requirements are not mandatory for stairs that aren't part of a means of egress for a building, compliance will ensure the stairs are safe and comfortable to use....
-
2.2.2.2 New York State Standards
Information and educational sessions can help ensure their understanding and compliance with the ALS standards (Johnstone l997)....
-
B. Patient Protection and Affordable Care Act and Section 510 of the Rehabilitation Act
Compliance with the standards becomes mandatory only when an enforcing authority adopts the standards as mandatory requirements for entities subject to its jurisdiction....
-
1015.3 Height
ETA Editor's Note Sections from California Building Code Chapter 10 that are not adopted by the Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
Supplementary Information:
However, adherence to the Guidelines does constitute a safe harbor in the Department's administrative enforcement process for compliance with the Fair Housing Act's design and construction...
-
INTRODUCTION
To ensure compliance with the standards, Congress established the Architectural and Transportation Barriers Compliance Board (ATBCB) in Section 502 of the Rehabilitation Act of 1973 (the...
-
Kohler Branham Urinal K-4920-T-0
Features Washout urinal 3/4" top spud 1 or less gallons per flush ADA-Compliant...
-
Swan Barrier-Free Folding Shower Seat BF-2300
Complies with Federal weight bearing and ADA code requirements of 250 lbs when properly installed....
-
Kohler Branham™ Urinal K-4920-R-0
Features Washout urinal 3/4" rear spud 1 or less gallons per flush ADA-Compliant...
-
11B-216.6 Entrances
[2010 ADA Standards] 216.6 Entrances....
-
11B-610.3 Shower compartment seats
[2010 ADA Standards] 610.3 Shower Compartment Seats....
-
11B-610.3 Shower compartment seats
[2010 ADA Standards] 610.3 Shower Compartment Seats....
-
11B-216.6 Entrances
[2010 ADA Standards] 216.6 Entrances....
-
Shelves, Sales and Service Counters, and Check-Out Aisles
However, shelves may be of any height since they are not subject to the ADA’s reach range requirements....
-
Hallways
ADA Requirements Wall-mounted objects located between 27 inches and 80 inches above the floor may not protrude or stick out from the wall more than 4 inches....
