EXCEPTION: A parallel approach complying with 305 shall be permitted at units for children's use where the spout is 30 inches (760 mm) maximum above the finish floor or ground and is 3 1/...
Search Results "9-1-1 Service"
-
602.2 Clear Floor Space
-
Nondiscrimination in Federally Assisted Programs: Policy Interpretations
Policy Interpretations INTRODUCTION The following four policy interpretations are issued by the Office for Civil Rights under the procedures announced in the FEDERAL REGISTER on May 1,...
-
f-iv
Notes: 1. At least 36 inches between handrails 2. Top landing part of walk 3. Bottom landing part of walk 4. Handrail height 34 to 38 inches 5. Edge protection....
-
217.5 Shelves for Portable TTYs
EXCEPTIONS: 1....
-
409.3.1 Power Operation
car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19 (1997 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)...
-
11B-403.7 Continuous gradient
The slope of the resting area in all directions shall be 1:48 maximum. ETA Editor's Note 2013 CBC requirement 11B-403.7 is not present in 2010 ADAS. ...
-
1002.4.4 Clearances
EXCEPTIONS: 1. Where provided, securement devices shall be permitted to overlap required clearances. 2....
-
PUBLIC BUILDING OR FACILITY
[DSA-AC] A building or facility or portion of a building or facility designed, constructed, or altered by, on behalf of, or for the use of a public entity subject to Chapter 1, Section...
-
407.3.3 Numeric Keys (Section-by-Section Analysis)
The requirement for a tactilely discernible “5” key derives from existing 508 Standards § 1194.23(k)(1), but would be a new requirement for the 508 Standards and 255 Guidelines....
-
4.34.3(4) Bins
Where bins are provided, for envelopes, waste paper, or other purposes, at least one of each type provided shall comply with the applicable reach ranges in paragraph (1), (2), or (3) of...
-
4.6.5 PASSENGER LOADING ZONES
Vehicle standing spaces and access aisles shall be level with surface slopes not exceeding 1:50 in all directions....
-
M301.4.2 Clearance Around Base
The width of the base permitted within this clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch...
-
1016.6 Openings
outdoor recreation access routes, passing spaces, and resting intervals such as spaces between the boards in a boardwalk and drainage grates to not allow passage of a sphere more than 1/...
-
903.4 Back Support
Back support shall be 2 1/2 inches (64 mm) maximum from the rear edge of the seat measured horizontally. ...
-
4.5.1 General
Exception 1. Fifty percent of the bins in multi-bin containers are exempt from section 4.5.1. Exception 2....
-
M302.4.2 Clearance Around Base
The width of the base permitted within this clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch...
-
§ 35.150(b)(2)(i) Safe harbor
technical and scoping specifications for those elements in either the 1991 Standards or in the Uniform Federal Accessibility Standards (UFAS), Appendix A to 41 CFR part 101-19.6 (July 1,...
-
11B-217.5 Shelves for portable TTYs
Exceptions: 1....
-
1133A.3 Removable base cabinets
Sinks and work surfaces required by Section 1133A.4 (see Item 1 and Item 2) shall be provided with knee and toe space complying with Section 1133A.7....
-
PRIVATE BUILDING OR FACILITY
[DSA-AC] A place of public accommodation or a commercial building or facility subject to Chapter 1, Section 1.9.1.2. [2010 ADAS] Private Building or Facility. ...
-
1133A.3 Removable base cabinets
Sinks and work surfaces required by Section 1133A.4 (see Item 1 and Item 2) shall be provided with knee and toe space complying with Section 1133A.7....