Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
Search Results "Side Transfer Surface"
-
1013.1 General
-
§ 38.159(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch (16 mm) in width....
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ...
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ◼ ...
-
1007.3.2 Golf Club Reach Range Area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole....
-
606.3 Height
Lavatories and sinks shall be installed with the front of the higher of the rim or counter surface 34 inches (865 mm) maximum above the finish floor or ground. EXCEPTIONS: 1....
-
American Standard Commercial Toilet Seat for Baby Devoro Bowls
For Baby Devoro bowls 2315.228 and 2282.001 Open front toilet seat less cover Available in White (020) Injection molded solid polypropylene EverClean® antimicrobial surface inhibits...
-
Clear Width of Circulation Paths and Maneuvering Clearances at Wheelchair Spaces
by seats, side walls, or wheel wells....
-
Grab Bars
Grab bars and any wall or other surfaces adjacent to grab bars must have rounded edges and are not allowed to have sharp or abrasive surfaces....
-
Shared Use Paths: ADA Standard Section 2.
address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width, grade, cross slope, surfaces...
-
11B-404.2.3 Clear width
In alterations, a projection of 5/8 inch (15.9 mm) maximum into the required clear width shall be permitted for the latch side stop. 2. ...
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
Restrooms Main Lobby
The restroom vestibule door does not have the required minimum of 18" maneuvering clearance on the latch side of the door. See Standards § 4.13.6. l....
-
Parallel Curb Ramps (R304.3) (Section-by-Section Analysis)
Where the turning space is constrained on two or more sides, the turning space must be 1.2 meters (4 feet) minimum by 1.5 meters (5 feet) minimum, with the 1.5 meters (5 feet) dimension...
-
C. Doors
_______________ ...with the exception of guestrooms not designated as accessible, does at least one door to each accessible space have at least 18" of clear floor space on the latch side...
-
Other Requirements in the ADA Standards
Automated Doors Maneuvering clearance is required on the egress side of automated doors unless they are equipped with standby power or they stay open in power-off mode (§404.3.2)...
-
1134A.7, Item 1
Water closets shall be located within bathrooms in a manner that permits a grab bar to be installed on at least one side of the fixture....
-
404.2.3 Clear Width
In alterations, a projection of 5/8 inch (16 mm) maximum into the required clear width shall be permitted for the latch side stop. 2....
-
Bradley Terreon Classroom Sink TCS Series
Terreon solid surface and TerreonRE recycled solid surface are now GREENGUARD Certified as low-emitting materials TAS compliant units available Coved backsplash Drilled or equipped...
-
E. What are the General Requirements for Curb Ramps in the ADA Standards for Accessible Design?
.) [§ 4.3.7] The ramp, or ramp run, must be at least 36 inches wide, not including the flared sides. [§ 4.7.3] The ramp run must have detectable warnings – i.e.,...
-
Feature 2 - Routes to the Building Entrance
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Wheelchair Spaces
Wheelchair spaces may be placed side-by-side, as reflected in specifications for width that are specific to adjoining spaces....
-
M303.2.3 Depth (Section-by-Section Analysis)
depth requirements based on how the wheelchair user enters the space: for spaces entered from the front or rear, 48 inches deep minimum; and for spaces that can only be entered from the side...
-
704.11 Parapets
walls, such framing and elements supporting such framing shall not be of less than 1-hour fire-resistance-rated construction for a width of 4 feet (1220 mm) measured from the interior side...
