EXCEPTION: A ramp with a slope no greater than 1:6 for a run not to exceed 2 ft (610 mm) may be used as part of an accessible route to an entrance....
Search Results "Curb Ramp Slope"
Filters
Commonly Searched Documents
-
4.1.7(3)(a)
-
4.1.7(2)(a)
EXCEPTION: A ramp with a slope no greater than 1:6 for a run not to exceed 2 ft (610 mm) may be used as part of an accessible route at an entrance....
-
EZ-ACCESS GATEWAY™ Solid Surface Portable Ramp
The Gateway™ Solid Surface Portable Ramp – the 1-piece design means no assembly or moveable parts; just set the ramp in the desired position, and it’s ready to use....
-
1.9.1.1.4
1.9.1.1.4 With respect to buildings, structures, sidewalks, curbs and related facilities not requiring a building permit, building standards published in the California Building Standards...
-
11B-505.2 Where required
Handrails shall be provided on both sides of stairs and ramps....
-
3.1.3.3 Cross Slope of Driveways
The cross slope of driveways shall not exceed 1:33 (3 percent). Exception....
-
CROSS SLOPE
CROSS SLOPE. The slope that is perpendicular to the direction of travel....
-
Running Slope
The slope that is parallel to the direction of travel (see cross slope)....
-
Cross Slope
The slope that is perpendicular to the direction of travel (see running slope)....
-
Cross Slope
The slope that is perpendicular to the direction of travel (see running slope)....
-
Running Slope
The slope that is parallel to the direction of travel (see cross slope)....
-
CROSS SLOPE
The slope that is perpendicular to the direction of travel (see running slope)....
-
RUNNING SLOPE
The slope that is parallel to the direction of travel. (As differentiated from the definition of “Cross Slope”.)...
-
RUNNING SLOPE
The slope that is parallel to the direction of travel. (As differentiated from the definition of “Cross Slope”.)...
-
Ramp
Ramp. A walking surface that has a running slope steeper than 1:20....
-
SECTION 1012 RAMPS
[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for...
-
Can curbs be used to indicate areas with less than 80” of vertical clearance?
Curbs may be mistaken for a step or change in level, instead of a barrier....
-
11B-303.5 Warning curbs
changes in level exceeding 4 inches (102 mm) in a vertical dimension between walks, sidewalks or other pedestrian ways and adjacent surfaces or features shall be identified by warning curbs...
-
1.2.2
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
-
Cross Slope
Cross Slope The cross slopes of gangways, transition plates and floating piers that are part of an accessible route must be designed and constructed not to exceed a maximum of 2 percent...
-
11B-405.7.1 Slope
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved....
-
Cross Slope
Cross Slope—The percentage of rise to length when measuring the trail tread from edge to edge perpendicular to the direction of travel....
-
1018.7.2 Cross Slope
The cross slope shall not be steeper than 1:48....
