Tips for Preparing Your Presentation and Content: Work closely with the event planners to learn more about your potential audience, and be prepared to modify your material or presentation...
Search Results "Kitchen Work Surface"
Commonly Searched Documents
-
Tips for Presenters
-
Text Telephones (TTYs) (Advisory Guidance)
If the garbled messages continue, this may mean that one of the TTYs is not working properly, there is background noise causing interference, or that you may have a bad connection....
-
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE: Paratransit Requirements for §5311-Funded Fixed-Route Service Operated by Private Entities
The term “other arrangement or relationship,” on its face, unambiguously refers to any means other than a contract through which a public entity works with a private entity to provide fixed...
- LaCantina Contemporary Aluminum Bifold Door System
- LaCantina Multi-slide Aluminum Sliding Door System
-
When is a Curb Ramp a Ramp?
[DSA-AC] A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face. 1991 &...
- Yale 1500 Series Traditional Exit Devices
- Besam SW100 Low Energy Swing Door Operator
- Landscape Forms Inc. Plexus Bench Collection
- ASI Global Partitions Phenolic Black Core Partition
- Kawneer North America 1040 Sliding Mall Front Door
- ASI Global Partitions Plastic Laminate Partitions
- Compliance Signs Van Accessible Parking Sign (Green Text on White)
- Ramp NOW Alumiramp Modular Ramps
-
Q1.) When a ramp has a maximum slope of 1:12 or 8.33%, is that considered a range of from 0% to 8.33% which would allow no slope greater than 8.33% or is that a simple maximum which would allow a tolerance above 8.33%? Similarly, is a cabinet countertop that can be no higher than 34” AFF a range of from 0” to 34” AFF with no additional height allowed, or is a tolerance allowed for variations in the floor surface or cabinet construction?
A1.) The consistent technical assistance on this question has been that both are subject to tolerances.
-
Conference Proceedings and Final Passage
Consequently, they worked closely with AIDS organizations to oppose the Chapman amendment....
-
806 Transient Lodging Guest Rooms
The Board has removed the minimum surface requirement (2 square feet) for vanity counter tops....
-
2. Background
., curb ramps and blended transitions, and detectable warning surfaces)....
-
4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302
These commenters argued that requiring the equipment to be designed to accommodate transfer in both positions would not achieve any objective benefit and would impose transfer surface width...
-
Bed Height Fact Sheet
All beds (including the railings, box spring, and mattress) within a mobility accessible (ADA) room should be no higher than 23” and no lower than 17” above the floor surface....
-
III-6.1000 General
The new floor must comply with, for example, ADAAG requirements for a nonslip surface or with the ADAAG carpeting requirements, if applicable....
-
Paragraph (e) (Advisory Guidance)
Controls which have non-slip surfaces and those that can be operated with the side of the hand, elbow or pencil can be used to minimize physical activity required....