The 48 inch (1220 mm) minimum by 36 inch (915 mm) minimum areas and the accessible route shall be permitted to overlap. Figure 406.7 Islands in Crossings...
Search Results "Fixed Route System"
Commonly Searched Documents
-
406.7 Islands
-
Entry Points and Seats
When play components are located on an accessible route, the height required to transfer directly to the entry point or seat of a play component has a minimum of 11 inches (280 mm) and a...
-
1007.1 Accessible means of egress required
In assembly spaces with sloped floors, one accessible means of egress is required from a space where the common path of travel of the accessible route for access to the wheelchair spaces...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
If the alteration to the play area only involves the surfacing, only the surface along accessible routes, clear floor or ground spaces, and maneuvering spaces must comply with the ASTM F...
-
R310 Passenger Loading Zones (Section-by-Section Analysis)
The access aisle must be 1.5 meters (5 feet) wide minimum, extend the entire length of the vehicle pull-up space, and connect to the pedestrian access route....
-
202.4.1 Disproportionate Cost
Costs that may be counted as expenditures required to provide an accessible path of travel may include: (i) costs associated with providing an accessible entrance and an accessible route...
-
208.1.1
The facility may not reduce the required number or dimensions of those spaces or unreasonably increase the length of the accessible route from a parking space to the facility....
-
210.1 General
In alterations, stairs between levels that are connected by an accessible route shall not be required to comply with 504, except that handrails complying with 505 shall be provided when...
-
Historic Preservation [4.1.7]
These requirements address accessible routes, ramps, entrances, toilet rooms, access between floors, and displays....
-
11B-246.1 General
Automobile access or accessible routes are not required when the enforcing agency determines compliance with this chapter would create an unreasonable hardship as defined in Chapter 2, Section...
- Equip for Equality
- BEA Inc. LZR-Microscan Swinging Door Sensor
- Teknion Journal
- American Standard Acrylic Shroud for American Standard Selectronic Faucets
- National Disability Rights Network
- OVCTTAC: Supporting Crime Victims With Disabilities Curriculum
-
Polling places that cannot be remediated with temporary measures:
Sidewalks & Walkways: The ramp on the route to the building has a vertical drop-off on at least one side and no edge protection is provided (1991 ADA Stds 4.8.7; 2010 ADA Stds 405.9)...
- Center for Independent Living of South Florida - Miami, FL
-
Voting Areas
ADA Requirements There must be a minimum 36 inch wide route in and through the voting area....
-
Ground Floor
In the final Guidelines, "ground floor" is defined as follows: "Ground floor" means a floor of a building with a building entrance on an accessible route....
- Yale Symphony® Integrated Wiegand Solution
-
After January 26, 1992
In addition, the route from the accessible entrance of the building to the renovated section must be made accessible to people with disabilities....
-
202.5 Alterations to Qualified Historic Buildings and Facilities
EXCEPTION: Where the State Historic Preservation Officer or Advisory Council on Historic Preservation determines that compliance with the requirements for accessible routes, entrances, or...
-
Negotiations Between the Senate and the White House
Second, concerning public transportation, the agreement included authority for the Secretary of Transportation to waive the requirement of bus lifts for fixed-route systems when lifts were...