telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side and forward...
Search Results "Forward Reach"
Commonly Searched Documents
-
11B-704.4.1 Height
-
ETA Public Telephone Summary Chart and Survey Instructions
If, in an exterior location, and dial tone first service is available, then a side reach telephone may be installed instead of the required forward reach telephone. [4.1.3(17)(a)3] g....
-
11B-308.1.2 Electrical receptacle outlets
Electrical receptacle outlets on branch circuits of 30 amperes or less and communication system receptacles shall comply with Section 11B-308 except the low reach shall be measured to the...
-
Measuring Techniques
Reach For reach and field-of-vision measurements, Air Force methodology is, once more, instructive....
-
11B-308.1.1 Electrical switches
by the occupant of a room or area to control lighting and receptacle outlets, appliances or cooling, heating and ventilating equipment, shall comply with Section 11B-308 except the low reach...
-
11B-704.4.1 Height
telephone because the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side and forward...
-
III-7.5185 Automated teller machines
The ADAAG standard now in effect provides that ATM's must meet the requirements for both a forward and a side approach....
-
11B-902.4.1 Clear floor or ground space
A clear floor space complying with Section 11B-305 positioned for forward approach shall be provided....
-
Storage: ADA Standard Section 225.2
Section 225.2 covers scoping requirements in the current ADA Standards for storage.
-
11B-404.2.4.3 Recessed doors and gates
Maneuvering clearances for forward approach shall be provided when any obstruction within 18 inches (457 mm) of the latch side at an interior doorway, or within 24 inches (610 mm) of the...
-
11B-225.2 Storage
Where provided, at least one of each type of storage must be within the reach ranges specified in Section 11B-308; however, it is permissible to install additional storage outside the reach...
- Boost Your Business - Chapter 7 - Halls and Fountains
-
11B-217.2 Wheelchair accessible telephones
1 bank At least 50 percent of telephone units per bank, but not less than 1 per bank At least 1 telephone per floor shall meet the requirements for a forward...
-
11B-411.4.6.1 Location
Controls shall be located within one of the reach ranges specified in Section 11B-308....
-
Clear Deck Space: ADA Standard Section 1009.2.3
The space shall be 36 inches (915 mm) wide minimum and shall extend forward 48 inches (1220 mm) minimum from a line located 12 inches (305 mm) behind the rear edge of the seat....
-
11B-1009.2.3 Clear deck space
The space shall be 36 inches (914 mm) wide minimum and shall extend forward 48 inches (1219 mm) minimum from a line located 12 inches (305 mm) behind the rear edge of the seat....
-
11B-809.10.8.1 Location
Lavatories without base cabinets shall be installed with the centerline 18 inches (457 mm) minimum from an adjoining wall or fixture to allow for forward approach....
- Maddak Wall Switch Extension Handle
-
Knee Clearance: Clearance as Measured from Anterior-Most Point - Manual Wheelchair
This depicts knee and toe clearance required by manual chair users for forward approach to elements in the built environment (e.g., light switches)....
-
T503 Passenger Access Routes
See 36 CFR 1192.23(a) (“All [covered] vehicles . . . shall provide . . . sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location.”), 1192.159...
- American Specialties Recessed Mounted Disposable Cartridge Soap Dispenser 5002
-
Teeing Grounds
Forward Teeing Ground—The forward teeing ground for each hole must be connected by either an accessible route or a golf car passage....
-
UDI
Reach measurements were obtained without touching the individual. Reaching abilities were measured both with and without “bending” although a definition of “bending” was not provided....